User manual AUDIOVOX AVT-597

[. . . ] Cleaning ­ Unplug this video product from the DC supplying outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Exception; A product that is meant for uninterrupted service and that for some specific reason, such as the possibility of the loss of an authorization code for a CATV converter, is not intended to be unplugged by the user for cleaning or any other purpose, may exclude in the cleaning description otherwise required. Attachments ­ Do not use attachments not recommended by the video product manufacturer as they may cause hazards. [. . . ] Electrical components that are likely to be replaced in the field and that are critical with respect to the safety are identified on the schematic diagram by the symbol of a exclamation point within a triangle. 3. Warning: This product included critical mechanical and electrical parts which are essential for X radiation safety. For continued safety replace critical components only with exact replacement parts given in the parts list. Operating high voltage for this product is 11KV at minimum brightness. POWER REQUIREMENTS POWER SUPPLY The AVT-597 is designed for 12 Volt operation. CAR BATTERY OPERATION A cigarette adapter cable is supplied for use in any 12 Volt, negative ground vehicle. Simply insert the DC plug on the end of the cable into the DC POWER JACK (13) on the back of the TV set and the other end of the cable into the cigarette lighter receptacle of the vehicle. The TV is now ready for operation. DC JACK Cigarette Lighter socket of car (12V) Remove plug from cigarette lighter receptacle when unit is not in use. POWER BUTTON 10. LED POWER INDICATOR 11. REMOTE CONTROL SENSOR -2- REAR 12. VIDEO INPUT JACK -3- BATTERY INSTALLATION Before attempting to operate your Remote Control, install batteries as described below. Press down on the ridged area of the battery cover and slide it off. Install two "AAA" batteries as shown. Make sure that proper polarity (+ or -) is observed. Slide the cover back until it clicks. -4- REMOTE CONTROL OPERATION (1) TV PARTS: 1. POWER ON/OFF Press this button to turn on the set. The channel number will be displayed on the screen, and the picture will appear in a few seconds. Press the button again to turn the set off. DIRECT ACCESS (0-9, 1--) BUTTONS Use these buttons to make a direct channel selection. The channel number chosen will be displayed on the screen for about 4 seconds. The direct access is carried out with 0-9 keys (099ch) and "1--" key (100-125ch). CHANNEL UP/DOWN BUTTONS Use these buttons to advance to the next higher (ù) or lower (ü) channel. VOLUME/PICTURE SELECTOR UP/DOWN BUTTONS Use these buttons to raise (ù) or lower (ü) the sound level, also used to make picture adjustments in picture selector mode. -5- 5. PICTURE SELECTOR BUTTON Each time this button is pressed, the on screen picture adjustment display cycles through "adjustment bars" for CONTRAST, BRIGHTNESS, COLOR, and TINT. Then use VOLUME UP/DOWN buttons to raise (ù) or lower (ü) the level. [. . . ] Press the AUTO PROGRAM button on the Remote Control Unit, you will see the TV cycle through all channels. The built-in Microprocessor will automatically note each channel that is actively broadcasting in your area. (1) Press the SKIP/SEARCH button on the Remote Control Unit until "SKIP MODE ON" is displayed on the bottom of the screen. From now on, whenever you use the CHANNEL UP/DOWN buttons on the front panel or the Remote control, the TV will stop only on active channels. (2) Press the SKIP/SEARCH button on the Remote Control Unit until "SKIP MODE OFF" is displayed on the bottom of the screen. [. . . ]