User manual AUDIOVOX AVT-988

[. . . ] 9" COLOR TV / MONITOR DC OPERATION WITH REMOTE CONTROL AVT-988 OPERATING INSTRUCTIONS SPECIFICALLY DESIGNED FOR THE VAN AND RV INDUSTRIES RECOMMENDED GUIDELINES FOR THE USE OF A VIDEO MONITOR IN A MOTOR VEHICLE · A VIDEO MONITOR / TV is designed for rear passenger viewing only. This product may only be installed in the rear seat compartment of the vehicle, out of the driver's view. · Installation in any other area of the vehicle, including anywhere within the driver's view, is illegal in most states, provinces and countries and may lead to driver distraction resulting in an accident, injury and or death. If you are unsure of regulations regarding this, please consult your local laws to determine how this applies to you. Users should be aware of possible noise distraction caused by the use of the product and should carefully monitor the volume so as not to interfere with the driver's attention to surrounding traffic conditions. · EXPLANATION OF GRAPHIC SYMBOLS: CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead within a triangle is intended to tell the user that parts inside the product are a risk of electric shock to persons. [. . . ] Press down on the ridged area of the battery cover and slide it off. Install two "AAA" batteries as shown. Make sure that proper polarity (+ or -) is observed. Slide the cover back until it clicks. - 6­ REMOTE CONTROL OPERATION 1. TV POWER Press the POWER button to turn ON the set. Direct Access (0-9, 1--) Number Buttons Use these buttons to select a channel. The channel number chosen will be displayed on the screen for about four seconds. To select channels 0-99, press two number buttons. For example, to select channel 8, press 0, 8. To select channels above 100, press the 1--button, then the number buttons for the last two digits of the channel. For example, to select channel 115, press 1--, 1, 5. CHANNEL s /t Buttons t Use these buttons to advance to the next higher (s) or lower (t) channel. (also used to select desired function on the menu). Volume +/- Buttons Use these buttons to raise (+) or lower (-) the TV sound level (also used to make picture adjustments in picture selector mode). - 7­ 5. Use s and t buttons to select desired function, then press ENTER button to end the choice. TV/VIDEO Button Press this button to access the AUDIO/VIDEO input jacks, on the front and rear of the TV. As the button is pressed, the on-screen display will cycle as follows: TV VIDEO 1 VIDEO 2 7. MUTE Button Press this button to turn the TV sound off. Press again to restore sound to the previously set level. MUTE may also be released by pressing the VOLUME +/- buttons. ERASE / ADD Button This button is used to manually add or erase any channel that is stored in the CHANNEL s / t memory. The stored channel numbers are displayed in GREEN on the screen and the non-stored channel numbers are in RED. [. . . ] General Specifications Our general specification for the voltage range of operation is 10 to 16 volts DC. TV's and VCP's (video cassette players) require slightly more than 10 volts to function properly. If voltage requirement does not create a problem, keep in mind the following points: Voltage The voltage of a fully charged battery (engine not running) is approximately 12. 5VDC. Once a load (items being powered represent the "load") is applied, the voltage will drop. [. . . ]