User manual AUDIOVOX AVT1345

[. . . ] Color Television AVT1345 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICICING TO QUALIFIED PERSONNEL. The lightning flash with the arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated " dangerous voltage" within the product' enclosure that may be of sufficient magnitude to s constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the appliance. WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE CAUTION CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER' AUTHORITY TO OPERATE THE EQUIPMENT. S NOTE TO CATV INSTALLER THI REMINDER IS PROVIDED TO CALL THE CATV SYSTEM INSTALLER' ATTENTION TO ARTICLE 820S 40 OF THE NEC THAT PROVIDES GUIDELINES FOR PROPER GROUNDING AND, IN PARTICULER, SPECIFIES THAT THE CABLE GROUND SHALL BE CONNECTED TO THE GROUNDING SYSTEM OF THE BUILDING, AS CLOSE TO THE POINT OF ENTRY AS PRACTICAL. CAUTION The AC power cord provided with this product is polarized (one blade wider than the other). [. . . ] Use the ù CH ü buttons to select " Memorize Channels" then use the ÿ VOL ÷ , button to enter the " Memorize Channels"process. Again press the ÿ VOL ÷ button to begin. Press the MENU button to return to set up menu. Press the MENU button three times to return to normal TV viewing. Your TV' channel memory will not be affected by a power outage. You will not need to res program the memory unless you change the type of cable or antenna connected to your TV. 10- Chapter 3: Operating your TV Changing Channels 1. The ù CH ü buttons will take you through all memorized channels, one by one. The ù CH ü buttons will not access channels that have not been programmed into the TV' memory. See the section, " s Programming Your TV's Channel Memory" on the previous page. The number buttons (0-9) will take you to any channel, even if it has not been memorized. To change to a channel enter it' number: the TV will tune to the new s channel when you enter the second digit of the channel. The PREVIOUS button will take you instantly to the last channel you were watching. Changing the Volume 1. To change the volume of the TV set, use the ÿ VOL ÷ buttons on the remote or on the front panel. To quickly turn off the sound, press the MUTE button on the remote. The " MUTE" will appear on the screen, colored green. To return the volume to its previous level, press MUTE again. Chapter 3: Operating Your TV-11 Changing the TV' Channel Memory s Your TV' channel determines the channels that are available using the ù CH ü buttons. s You can add channels to this memory or remove them from memory. If a channel is removed from memory you can tune to it with the ù CH ü buttons. If there is just one channel memorized, then the Add/Delete Channels function will search the whole channels. But if there are two or more channels memorized, then the Add/Delete Channels function will search the memorized channels only. Use the number buttons to tune to the channel. Press the MENU button twice, then " Set Up" menu will display. [. . . ] · The channel may not be programmed into memory. The picture rolls, slants, shows lines, is grainy, has poor color or has ghosts. · Try another station, if the other station is OK, it may be a station problem. · Check that the antenna is connected, is in good working order, has no broken wires and is adjusted correctly. [. . . ]