User manual AUDIOVOX AWM900S

[. . . ] IMPORTANT NOTES Avoid installing unit in locations described below: -Places exposed to heat radiating appliances such as electric heaters -On top of other stereo equipment that radiates too much heat -Places lacking ventilation or dusty places -Humid or moist places Features: -AM/FM Wallmount Stereo with CD Player -Digital Display Type Tuner -Locking Power/Speaker Connector -Clock/Alarm -2-Channel (Left, Right with A/B Speaker Outputs) -Auxiliary input Function -Backlit Controls -Reverse Polarity Protection -50 Watts Power Output -12VDC -Bass/Treble -Preset EQ (Rock, Pop, Classis) -Alarm Defeat Switch REAR PANEL FEATURES -External Fuse Holder -Main Wiring Pigtail with Locking Amp Connector (12-Pin) -Auxiliary Input Phone Jacks (Left and Right) Manual contents: Features-Manual contents Controls Identification Operation Instructions Hook Up Wiring Color Code Installation Specifications Warranty Statement Page: 2 3 4-5 5 6 6 7 Page 2 Controls Identification: Controls Identification 1) Display Window 2) CD Play/Pause Button 3) Band(AM/FM) Button 4) AUX Selector Button 5) Alarm Set Button 6) Alarm On/Off Buttons 7) CD Eject Button 8) Radio Tuning Control 9) Audio Adjust Selector Button (Volume, Bass, Treble, Balance) 10) Power Switch 11) Mute Button 12) Stereo Headphone Jack Speaker Selector Volume Up Control Button Volume Down Control Button Time/Frequency Selector Button Preset EQ Button (Rock, Pop, Classic) 18) Reset Button 19) Track Up / Minute Set Button 20) Track Down /Hour Set Button 21) Fuse 22) FM Antenna Terminals 23) Car Antenna Jack- 75 Ohm 24) RCA Auxiliary Input Jacks 13) 14) 15) 16) 17) Page 3 Operating Instructions: NOTE: Number in parenthesis (#) corresponds with "Control Identification" on page 3. LIQUID CRYSTAL DISPLAY PANEL The liquid crystal display (LCD) panel displays the frequency, time and activated functions. Note: It is characteristic of LCD panels that, if subjected to cold temperatures for an extended period of time, they will take longer to illuminate than under normal conditions. [. . . ] 2) Using the source Selectors (4), choose the button labeled "AUX". 3) If there is an external source (example: CD shuttle) connected to the Auxiliary Input Jacks (24) on the rear of the radio, then you can listen to your external source through the system. SETTING THE CLOCK 1) Push Power Switch (10) "On". 2) Press the T/F button to display the clock 3) Hold the T/F button (16) and simultaneously use the H and M buttons (19 and 20) to adjust hours and minutes. Note: The T/F also toggles between time and radio frequency on the display. USING THE AUDIO ADJUST BUTTON 1) You can toggle between volume, treble, bass and balance control by pressing the Audio Adjust button (9) 2) Once at the desired function, you can use the volume buttons to adjust. SETTING THE ALARM 1) Hold the Alarm set button (5) 2) Use the H and M buttons (19 and 20) to adjust hours and minutes. 3) The alarm On/Off button (6) activates or deactivates the alarm. BEEP FEATURE 1) Hold the Audio Adjust button to enable the beep feature (9). Lower right side of the display will display an audio symbol when this feature is turned on. 2) When this feature is on, turning different features on or off will produce two different tones, higher tone for ON and lower tone for OFF. 3) Completely removing power from the unit will turn the beep feature off. Page 5 Wiring Color Code: WIRING COLOR CODE FOR AWM-900S COLOR ORANGE/WHITE STRIPE GREEN/WHITE STRIPE BLACK/WHITE STRIPE WHITE VIOLET BLUE LIGHT GREEN RED VIOLET/BLACK STRIPE YELLOW LT GREEN/BLACK STRIPE FUNCTION +12VDC IGNITION POWER +12VDC BATTERY POWER POWER GROUND (-12VDC) LEFT (A) SPEAKER (+) LEFT (A) SPEAKER (-) RIGHT (A) SPEAKER (+) RIGHT (A) SPEAKER (-) LEFT (B) SPEAKER (+) LEFT (B) SPEAKER (-) RIGHT (B) SPEAKER (+) RIGHT (B) SPEAKER (-) Page 6 Installation: 1) Cut a mounting hole in the desired location using mounting hole diagram (below) and use the four 3x20min self tapping screws provided to mount the unit. 2) Route power, speaker and antenna cables through hole and connect to unit as outlined in the Wiring Color Code diagram on the previous page. 3) After making sure connections are correct, test operation. Specifications: Operating Voltage: Output Power: Output Wiring: Output Impedance: Tuning Range: Sensitivity FM Stereo Separation: CD Frequency Response: CD Channel Separation: CD S/N Ratio: CD Distortion: SizeOverall Size: Mounting Size: Weight: 11-16VDC 50 Watts Total (25 Watts per Channel) 2/4 speaker and Headphone System Compatible with 4-8 Ohm Speakers, 4 Ohm Load Min. (AM)530-1720 KHz (FM) 87. 5-108 MHz (AM) less than 15uv (FM) less than 2. 5uv More than 30dB 20-20, 000 Hz 50dB 60dB 0. 3% 10. 43"(W)x7" (H)x6. 26 (D) 265mm(W)x178mm(H)x159mm(D) 9. 25"(W)x6. 05"(H)x5. 25"(D) 235mm(W)x154mm(H)x133mm(D) 4 lbs. (1. 8 Kg) Page 7 WARRANTY 90 DAY / 12 MONTH LIMITED WARRANTY AUDIOVOX SPECIALIZED APPLICATIONS, LLC (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced (at the Company's option) without charge for parts and repair labor. After the initial 90 day period and for a period of 12 months from the date of the original purchase, the Company will supply at no charge a replacement for any defective part(s). [. . . ] ANY ACTION FOR BREECH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 30 DAYS FROM THE DATE OF ORIGINAL PURCHASE. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREECH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED WHATSOEVER. No person or representative is authorized to assume for the Company any liability other that expressed herein in connection with the sale of this product. [. . . ]