User manual AUDIOVOX CE506SLK

[. . . ] · When there is condensation inside the unit, the unit may not function normally. · Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use. AUX JACK · To listen to audio signals from external unit through this unit: Connect the red plug to the R jack, and the white plug to the L jack of the AUX in connector. FCC INFORMATION (For USA ONLY) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] NOTE: DO NOT CONNECT TO AN OUTSIDE ANTENNA. Connect the loop aerial (provided) to the "AM LOOP ANTENNA" snap terminals at the back of the unit. SLEEP/TIMER DISPLAY 2. While "TIMER" indictor blinks on the display, press and hold MEMORY button about 3 seconds until hour blinks on the display. SLEEP SETTING When the sleep timer is used, the power is automatically turned off after the specified time passes. FUNCTION 7. Set volume level and X-Bass, and then press POWER button to standby mode. MEMORY 1. Press SLEEP button while the power is on. "SLEEP 90" appears on the display. Note: SLEEP can be adjusted in TUNER, CD and AUX modes. 2. Press SLEEP button repeatedly to select the length of remaining time until the unit turns off. It changes the indicator in the following way: 90 80 70 TO SEARCH FOR A STATION AUTOMATICALLY Press and hold TUNING / SKIP button for 1 to 2 seconds, and the tuner starts searching for a station for automatically. After tuning in to a station, the search stops. The search may not stop at a station with a very weak signal. TO RECEIVE THE FM BROADCAST IN STEREO When the reception is good, the "STEREO" indicator will appear on the display. TUNER STEREO FM TUNING 3. Press buttons to set hour. / SKIP POWER ON SLEEP/TIMER 10 SLEEP MHz 8. When the preset time reaches, the system will turn on automatically and "TIMER" indicator will blink on the display. TUNING TUNING TIMER AM If the sleep timer is set, the word "SLEEP" will be shown on the display. To cancel the sleep timer, press SLEEP button once and "SLEEP" disappears on the display. 4. The minute will NOTE: Once the sleep time reaches, the power will be turned off atuomatically. PRESETTING STATION You may tuned in to a stored station directly by entering the preset number. It is possible to store stations of any band in your choice order. Manual memory presetting This feature allows you to manually preset stations to any desired channel. Press REPEAT/PRESET button to select a channel number for the preset station. MEMORY TUNING / SKIP 5. Press buttons to set minutes and press MEMORY button to confirm, finally "TIMER" indicator will stop blinking after several seconds. 9. If you want to snooze a few more minutes. You can press SNOOZE button (on the Remote Control), the system will go to standby mode ("SNOOZE" indicator appear on the display) and then turn on again 5 minutes later. You can repeat this function as many as you desired within 60 minutes from the preset automatically PLAY timer. SNOOZE LISTENING TO THE RADIO TUNING IN TO A STATION MANUALLY 1. [. . . ] Before playing, wipe the disc from the center out with a cleaning cloth. After playing, store the disc in its case. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 1. 16. DISPLAY button STANDBY / ON button FUNCTION (TUNER/CD/AUX) button PRESET/REPEAT button STOP/BAND button TUNING / SKIP/SEARCH buttons MEMORY button RANDOM button SLEEP button SNOOZE button PLAY/PAUSE button TUNING/ SKIP/SEARCH buttons X-BASS button INTRO button TIMER button VOLUME +\- controls Specifications subject to changed without notice. CLEANING THE UNIT Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth. [. . . ]