User manual AUDIOVOX CTX4100A

[. . . ] NOTE: If the CTX4100A is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. if the cable is disconnected , the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit. Only connect the unit to a12-volt power supply with proper grounding. [. . . ] Once setup, the parental lock is released only by entering the correct password. Once the correct password is entered, you can access the "Password" field and enter a new one. NOTE: Record the password and keep it in a safe place for future reference. the rating for each disc is marked on the disc , disc packing , or documentation. If the rating is not available on the disc, the parental lock feature is unavailable. Some discs restrict only portions of the disc and the appropriate content will play. Subject to technical changes Hardware Sub-menu Features If the rear-view video camera is connected, the unit is on, and the TFT monitor is retracted inside the unit, the TFT monitor automatically moves into the viewing position and Camera mode is selected upon shifting into REVERSE gear. When shifting into DRIVE gear, the TFT monitor is retracted back inside unit. When the reverse driving stops, the monitor return to its original input mode. After entering calibration mode, a crosshair appears in a corner quadrant of the screen. To begin calibration, press and hold the crosshair for one second until it moves to the next quadrant. fast Forward Playback Press the >> button (14) on the remote control , the /\ button (15) on the joystick , or the >> button on the screen to fast forward. Keep pressing and releasing the button to increase the rate from "2X" to "4X", "8X", and "20X". Press >/|| (18) on the remote control or touch the onscreen play button (>) to resume normal play. Button on screen to alter repeat mode according to the NOTE: For VCD play, the repeat function is not available if PBC is on. Press the RPT A-B button again once you reach the desired end point (B) of the repeated section. Press the RPT A-B button again to cancel the A-B section setting and stop repeat play. NOTE: When a VCD is playing with PBC turned "On", activating random playback automatically turns PBC off. Random Playback With a DVD, VCD, or CD playing, press the RDM button (33) on the remote control to activate random playback and play all chapters/tracks in random order. Press the >>| button (19) on the remote control or the > button on the joystick (14) to play the next random track. Press the RDM button again to turn random play off. NOTE: When a VCD is playing with PBC turned "On", activating random playback automatically turns PBC off. [. . . ] Repeat Playback Press the REPT button (7) on the remote control to alter repeate mode according to the following : Repeat Single, Folder Repeat, Repaet Off NOTE: CD-R and CD-RW will not play unless the recording session is finalized. Subject to technical changes GENERAL Unit will not power on Radio Fuse blown Car battery fuse blown Illegal operation Install new fuse with correct rating Install new fuse with correct rating Press the RESET button located in the bottom right corner of the front panel Replace battery with new one Remove battery and install correctly Check wiring and correct Increase volume level Review wiring diagram and check "MUTE" connection Replace speakers Adjust the channel balance to the center position Insulate all speaker wiring connections Use original copy Connect proper speakers Check speaker contact Check that the "MUTE" connection is not grounded and that it's properly insulated Check wiring and correct Battery depleted Battery installed incorrectly Improper audio output connection Volume set too low Improper "MUTE" connection Speakers damaged Heavily biased volume balance Speaker wiring is in contact with metal part of car Pirated disc is in use Speaker power rating not compatible with unit Speaker is shorted "MUTE" wire is grounded Incorrect connection between ACC and positive battery wire Tel-Mute malfunction Unit resets itself when engine is off TFT Auto Open is turned off Incorrect connection to parking brake wire PRK SW is activated, parking brake is not engaged Turn TFT Auto Open on Check wiring and correct Stop vehicle in safe place and apply parking brake DVD is not compatible with current TV system settingsChange setup to accommodate disc Improper video signal connections Check wiring and correct Use correct aspect ratio setting Press OPEN key to restart monitor movement TUNER Weak station searching Auto antenna is not fully extended Auto antenna not properly connected LOCAL function is activated Disc is warped or scratched Disc is dirty or wet Laser pickup is dirty Incompatible disc is used Disc rating exceeds Parental Lock rating limit Disc region code is not compatible with unit Disc is inserted upside down Subject to technical changes Connect the auto antenna control cable properly Connect the auto antenna control cable properly Turn LOCAL function Disc does not play back Use disc in good condition Clean disc with soft cloth Clean laser pickup with cleaning disc Use compatible disc Change Parental Lock settings to lower restriction Use disc with proper region code Image blurred, distorted, or dark PCB cannot be used during No repeat or searching MP3 Interruption occurred during playback Use original disc PCB is not available on the disc PCB is on Turn PCB off Clean disc or replace Recreate disc with good files Message is longer than LCD can display Disc is being read Disc is dirty Disc is upside down Disc not present in loading compartment Disc is dirty Disc is upside down Disc format is not compatible with this unit DVD is not compatible with region code of unit Illegal mechanism operation Clean disc with soft cloth Insert disc with label side up Insert disc Clean disc with soft cloth Insert disc with label side up Press EJECT key for 5 seconds to reset loading mechanism Subject to technical changes Use only a clean silicone cloth and neutral detergent to clean the front panel or monitor. A rough cloth and nonneutral detergent (such as alcohol) may result in scratching or discoloration. If the temperature inside the player gets too hot, a protective circuit automatically stops play of the disc. [. . . ]