User manual AUDIOVOX EZCRG Owners Manual

[. . . ] Failure to do so may result in the console becoming a projectile in the event of an accident. Before working under the vehicle, block the wheels to prevent accidental injury. Before drilling any holes in the vehicle, verify that the drill bit will not enter into the frame rail(s) of the vehicle of damage electrical wires, fuel lines, brake lines, hoses, exhaust system components or any other items that will impair that operation of the vehicle. The console must be secured to the floor panel of the vehicle. [. . . ] Apply a firm push forward to mate the console base and the floor mounting plate, with the tongue of the mounting plate projecting into the slot of the console base. Place the spring washer on the 2 console bolts. Place the console bolts through the mounting plate and into the two holes at the rear of the console base. Tighten the console base bolts with a Phillips screwdriver. Powering the unit (Refer to Figure 3) NOTE: Have all the wires, such as the power cord, AV cables and external antenna cable, or CATV cable, pass through the two notches at the bottom of the door. Plug the cigarette lighter cord into the 4-PIN DC input jack on the back of the console. Then reinstall the console rear door and press the latch to close the door. Plug the other end into the cigarette lighter receptacle in the vehicle. NOTE: If the unit draws in excess of 10 Amperes, the power supply will deactivate and turn off the unit. 6 DETAIL DC 12V INPUT DC 12V DOOR DOOR LATCH VIDEO L AUDIO R OUTPUT ANTENNA TERMINAL ANTENNA JACK NUT ANTENNA JACK OF FOIL DIPOLE CABLE NOTCHES Figure 3 7 H. Connecting an External Antenna (Refer to Figure 3) 1. Originally, the antenna jack of the built-in foil dipole has already been connected to the antenna terminal behind the door at the rear of the console. In case of poor images with the foil dipole, loosen the nut around the antenna jack, unplug the antenna jack, and connect the coaxial cable of an external antenna to the antenna terminal. In addition to normal broadcast reception of VHF and UHF channels, you can connect the CATV cable directly to the antenna terminal for CH1 ~ CH125 reception. Press the power button to turn on the unit. The unit will enter the mode last committed to memory. Press the TV/AV button to select the desired TV mode. Press the auto program button to automatically search and store the channels using the on-screen display. When the channel number on the screen turns from red to green, the unit starts to play the 1st channel automatically. Press the channel up and down buttons to access your desired channel. Adjust the volume controls for individual preference. If the picture needs to be adjusted, use the picture button to illuminate the on-screen display for contrast, brightness, color and tint in sequence, and use the volume button to adjust each function up or down. With power applied to the unit, select the AV mode by pressing the TV/AV button, and push the tape cassette gently into the compartment of the VCP. [. . . ] Press this button once in the (fast) forward mode; the VCP enters the reverse picture search mode and the tape will rewind rapidly with the pictures. Press this button once more, and the tape will rewind at a high speed. You can also press this key to release special operations such as the search modes. STOP Button Press this button to stop tape, and press it once more to eject the tape. [. . . ]