User manual AUDIOVOX FP1510

[. . . ] This product should never be placed near or over an heat vent. Make sure to keep products away from direct sunlight at the build in position. Do not mount the product where it will obstruct the development of the airbag or in an area where it would affect the vehicular control. [. . . ] Installation Quality installations are best performed by qualifield and certified installers. Cleaning the screen Use only a damp cloth to clean the screen and use purified water on the cloth wiring out all excess water prior to wiping the screen. Do not use any cleaners or chemicals to clean the screen. Liquids If there is any liquid on these products, pull your vehicle to the roadside and turn the key off to disconnect or wipe the products with a towel. Do not operate the equipment until all liquids habe either evaporated or you have the monitor was inspected at the service center by a qualified technican. Watching the monitor without engine running Watching the monitor for an extended period of time without engine running may deplete the vehicle´s battery charge. 13 Subject to technical changes Caution: Please oberserve the right polarity of the cables and the right colours of the RCA-Plugs. 14 Technische Änderungen vorbehalten Method 1: Installation with Stand Mount at first the stand at an appropriate postion. in the dashboard with the supplied screws. Observe by any means, that you don´t damage wires, cables or other preinstalled parts in the vehicle. At first remove carefully the mounting frame of the monitor´s rearside. With the Power ON / OFF button you can switch the monitor ON / OFF. Be sure the VCD or DVD is working, the monitor will display the normal photo then, this main unit will distinguish automatically from the model PAL and NTSC video signal. If you connect them right, the clear and colorful screen will be on. Using the remote conrol you can adjust the brightness, color and contrast. The remote key of overturn can turn the picture clockwise. The monitor included a built in IR headphone transmitter which allows the use of wireless headphone. The remote control button V1/V2 allow to switch between the booth input sources. remote control button, offer you a quik access to pre adjusted picture settings. Otherwise a manual picture adjustment is possible with the brightness / color and contrast ratio buttons of the remote control. 17 Trouble Shooting Power This product is designed for operation with a 12 Volt DC, negative ground vehicle. [. . . ] Too low voltage or wrong polarity my cause malfunctions. Service Do not try and service these products yourself, seel only a qualified service center or factory service center. Damages Be careful not to drop or apply undue pressure to the frontpanel of your video monitor. [. . . ]