User manual AUDIOVOX FR-100

[. . . ] Holding the button will continuously decrease the channels number until the button is released. Call Button: Press to send a ringing sound to other radios tuned to the same channel. Channel Display: Displays the channel selected (1-14). Transmit Indicator (TX): Illuminates while transmitting. [. . . ] Pressing the Push-to-Talk (PTT), monitor, channel select or call buttons, will illuminate the display. The display will remain lit for 5 seconds after any of these buttons is pressed. 1. 3. Illuminates green when transmitting Illuminates red when the battery power is low. 14 Displays the current channel number (1 to 14). -6- BATTERY INSTALLATION Your FR-100 requires four "AAA" alkaline cells. Alkaline batteries will provide the best performance from your transceiver. Remove the battery cover by rotating the belt clip away from the battery compartment. Remove the battery cover by releasing the clasp at the bottom of the compartment. Observe the polarity symbols inside the battery tray when installing the batteries. CAUTION: Incorrect battery installation can damage the unit. BATTERY SAVER MODE Your FR-100 has a unique circuit designed to dramatically extend the life of its batteries. After five seconds of inactivity, the FR-100 will switch to battery saver mode and the display will turn off to conserve battery life. While in battery saver mode, the transceiver will remain ready to receive any incoming transmissions. Pressing any of the buttons will exit the battery saver mode and illuminate the display. -7- USING YOUR FR-100 Turning the Transceiver on Rotate the POWER ON /OFF-VOLUME CONTROL clockwise to turn on the transceiver and increase the listening volume level. The speaker will play a confirmation beep tone to confirm the transceiver's activation. n Do not use this device in or near a mining facility, which uses remotely triggered explosives or in areas labeled "Blasting Area". Premature or accidental detonation may result. n Do not attempt to modify or in any way increase the output of this transceiver. Its output is designed to meet the legal limits set by the FCC. n Do not use this device or change its batteries in potentially explosive atmospheres as sparks in such areas could result in an explosion. n Turn your transceiver off wherever posted notices restrict the use of radios or cellular telephones. Facilities such as hospitals may use equipment that is sensitive to RF energy. n Turn your transceiver off on-board aircraft when requested to do so. n Do not place your transceiver in front of a vehicle's air-bag. If the air-bag deploys, it could propel the transceiver like a projectile. regulations for use in the United States. [. . . ] They represent typical values, individual units may vary. Channel Frequencies: Channel 1 2 3 4 5 6 7 MHz 462. 5625 462. 5875 462. 6125 462. 6375 462. 6625 462. 6875 462. 7125 Channel 8 9 10 11 12 13 14 MHz 467. 5625 467. 5875 467. 6125 467. 6375 467. 6625 467. 6875 467. 7125 -12- 90 DAY LIMITED WARRANTY Applies to Audiovox Family Radio Service Products. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 90 days from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor. To obtain repair or replacement within the terms of this Warranty, the product is to be delivered with proof of warranty coverage (e. g. [. . . ]