User manual AUDIOVOX FR-531 Owners Manual

[. . . ] Unauthorized antennas, modifications, or attachments could damage the transmitter and may violate FCC regulations. Normal Position: Hold the transmitter approximately 1" from your face and speak in a normal voice, with the antenna pointed up and away. -4- 128-6255 4 of 16 FUNCTION AND LOCATION OF THE CONTROLS 16 15 14 13 11 2 12 7 10 3 VOX CALL PWR MIC 8 4 9 5 1 6 4 (REF) -5- 128-6255 5 of 16 1. Power Button: Press and hold this button for 2 seconds to turn the transceiver on or off. Push-to-Talk Button (PTT): Press to transmit. [. . . ] If unattended the unit will eventually turn off. Monitor Button You can monitor channel activity by pressing the Monitor (M) button (3). If pressed and held for more than 2 seconds, you can continuously monitor -9- 128-6255 9 of 16 channel activity. Press again, momentarily, and monitoring is disabled. Pressing this button momentarily will cause the unit to beep and the LCD backlight function will be activated for 5 seconds. FUNCTIONS Function (F) Select Button (12) Pressing this button will allow selection of frequency channels as well as selection of the various unit functions. Each press permits selection of the desired channel (1­14), beep tone, scan, and Dual Watch mode. This button also activates the Key lock feature when pressed and held for more than 2 seconds. The Key lock icon ( ) appears on the display. To unlock this function, press and hold the function button for 2 seconds. Channel Selection Press function button once or until two-digit channel display flashes. Press Up or Down buttons (10, 9) to select desired channel (1­14). Beep Confirmation Tones Whenever the Up/Down or function select buttons are pressed, the speaker will sound a beep tone to confirm each press, provided the key tone feature is enabled. Press the Function (F) button twice to access the beep tone feature. To disable the key tone, press the F button until the Beep Tone icon ( ) flashes; On appears on the display. Then press Up or Down buttons until oF appears and icon disappears. To enable the key tone, proceed as before, until oF appears and Beep Tone icon flashes. Then press Up or Down button so that On appears. Key tone icon is -10- 128-6255 10 of 16 steady and beep tone is heard. When increasing the volume or channel number, the tone will be higher than when decreasing the volume or channel number. Channel Scanning Press function button three times until the SCAN icon flashes; oF will also appear on the display. Press the Up or Down button to enable the Scan function; On will appear and the SCAN icon will appear steady on the display. While in Scan mode, the unit will rapidly scan each channel in the upward direction and then repeat. If and active channel is encountered, scan will pause on the active channel for 5 seconds, and then proceed to the next higher channel. The unit will thus scan channels 1­14 for activity. Scanning will continue until the Function (12) button is pressed. [. . . ] dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. The Company disclaims liability for communications range of this product. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. [. . . ]