User manual AUDIOVOX FR560FM Owners Manual

[. . . ] If you wear the handset on your body while using the headset accessory, use only the Audiovox supplied belt clip for this product and ensure that the antenna is at least 1 inch (2. 5 centimeters) from your body when transmitting. Unauthorized antennas, modifications, or attachments could damage the transmitter and may violate FCC regulations. Normal Position: Hold the transmitter approximately 1" from your face and speak in a normal voice, with the antenna pointed up and away. -5- FUNCTION AND LOCATION OF THE CONTROLS 13 15 14 2 9 4 3 1 12 5 11 10 8 7 6 -6- 1. Power Button (PWR): Press and hold this button for 2 seconds to turn the transceiver on or off. [. . . ] This button also activates the Key lock feature when pressed and held for more than 2 seconds. FM Frequency and Preset Memory Selection The transceiver is capable of receiving radio signals in the FM band, and is also equipped with nine preset FM memory locations. The presets allow the user to choose the nine most-used FM stations and store them for quick access. To enter the FM mode, press the function repeatedly until the FM icon blinks. Press the Up ( ) button and the FM icon becomes steady. The transceiver will receive the FM frequency displayed. To select an FM frequency while in the FM mode, press the function button. The FM radio frequency icon will start to blink. Press the Up ( ) or Down ( ) buttons until desired frequency is reached. Once the desired frequency is reached, press the PTT button once or the Function ( F ) select button twice. To exit the FM mode, press the Monitor (M) button and the transceiver returns to the FRS mode. To recall a preset FM frequency while in the FM mode, press the Function ( F ) button repeatedly until MEM display appears. Using the Up ( ) or Down ( ) buttons, select the desired memory preset ( 1 thru 9 ). To store an FM station press the function button until FM display flashes. Press Up ( ) or Down ( ) buttons to select desired FM station. Then press function (F) button until MEM display flashes. -11- Using Up ( ) or Down ( ) buttons, select desired memory position (1­9) for selected station frequency. Press and hold CALL button to lock station frequency into selected memory position. FM Auto Scan To automatically search for an FM station, press and hold the Up ( ) or Down ( ) button while the FM radio frequency display is blinking. When a strong FM frequency is encountered, scanning will stop and the FM display will blink. Once the desired frequency is reached, press the PTT button once or the Function ( F ) select button twice. This feature is useful in areas where reception of usual FM stations is poor, and local information is needed. Beep Confirmation Tones Whenever the Up/Down or Function (F) select button is pressed, the speaker will sound a beep tone to confirm each press, provided the key tone feature is enabled. The unit will also transmit a beep tone sequence after each transmission to signal the receiving party that transmission has ended. [. . . ] dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. The Company disclaims liability for communications range of this product. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. [. . . ]