User manual AUDIOVOX GMRS-WP1 Owners Manual

[. . . ] YOU WILL NEED TWO FORMS FROM THE FCC; FCC FORM 159 AND FCC FORM 605 MAIN FORM AND SCHEDULE F. YOU CAN FIND THE FORMS ONLINE AT: HTTP://WWW. FCC. GOV/FORMPAGE. HTML, OR CALL 1-800-418-3676. -2- 128-6739 2 of 16 PERFORMANCE Your transceiver will achieve its maximum operating range when communicating with other transceivers in a flat open area with no trees or buildings obstructing its signal. Range may be up to two miles under such conditions. [. . . ] CAUTION: Incorrect battery installation can damage the unit. Never attempt to charge alkaline batteries. 1. Press down on the spring latch securing the clip to radio and slide the clip downward and away from the mounting stud. 2. At battery cover, press downward with thumb on embossed arrow and slide battery cover down and off the radio. 3. Insert four "AAA" batteries. Position batteries according to polarity markings. Reverse the procedure outlined in steps 1 and 2 to reassemble. NOTE: Make sure the battery + and - terminals are aligned as shown. -7- 128-6739 7 of 16 The following guidelines will improve performance and provide longer operating times for the GMRS-WP1: 1. The use of alkaline-type batteries is recommended to provide the longest operating time. Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries can cause damage to the unit and will void the warranty. SPK/MIC (CHG) JACK RED CHARGE LED AUDIO OX Direct Plug-In Transformer Unit UL LISTED 65NM E203081 UL C + NOTE: Only Audiovox approved rechargeable batteries (P/N FRSRBAT) can be recharged in the radio transceiver. CALL AC WALL CHARGING ADAPTER, MODEL WP1CHG (SOLD SEPARATELY) INPUT: 120 VAC OUTPUT: 8 VDC VOL VOX HI LOW OFF -8- 128-6739 8 of 16 USING YOUR GMRS-WP1 Turning the Transceiver On and Off ( ) Pressing the Power button (10) for 2 seconds will activate the unit and the self-test display momentarily appears followed by the frequency standby display. The headphones will sound a short melody to confirm the transceiver's activation and the LCD backlight will come on for about 2 seconds. To turn the unit off, simply press and hold the power button for 2 seconds then release it; a short tone will be heard as the unit powers off. Volume Level Audio reception volume is controlled by the Up (13) and the Down (12) channel/ volume buttons. Momentarily pressing either button will increase or decrease the volume level, with each step accompanied by a beep tone whose volume increases or decreases accordingly. The display will indicate U1 (lowest setting) to U7 (highest setting). Call Button (14) When the call button is pressed, the GMRS-WP1 will transmit a 3-second ringing sound to other transceiver's tuned to the same channel. This feature can be used to signal other parties that voice communication is desired. The LCD backlight comes on for about 3 seconds, indicating the call transmission has been initiated. Low Battery Alert When the battery level becomes low, the LCD channel display will flash at a 1-second rate, indicating that the batteries should be changed. Monitor/FM (MON/FM) Button (9) You can monitor channel activity by momentarily pressing the Monitor (MON) button (9). If pressed for more than 2 seconds, the FM function is accessed, whereby Fr appears momentarily on the display. [. . . ] dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. The Company disclaims liability for communications range of this product. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. [. . . ]