User manual AUDIOVOX LCM1042TV

[. . . ] LCM1042TV Owner's Manual CHANNEL AP TV/AV VOLUME PIC. SEL. Audiovox Specialized Applications, LLC 23319 Cooper Dr. Elkhart, IN 46514 1-800-688-3135 www. asaelectronics. com US PATENT # D413, 856 Important Notice It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver's seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, the LCM1042TV should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle. [. . . ] In "SKIP mode" the TV only stops on channels that are programmed into memory when the CHANNEL UP/DOWN buttons are pressed. When SKIP is turned off, the TV will advance to next channel/previous channel number when channel up/down is pressed. ERASE / WRITE BUTTON When tuned to a channel, press this button to store or erase the channel from memory. The stored channel numbers are displayed in green on the screen, and the non-stored channels are in red. When skip mode is on, the LCM1042TV will tune to only the stored channels when using the CHANNEL UP/DOWN buttons. AUTO MEMORY BUTTON Press this button, the TV will automatically scan and memorize the strong signal channels 12. PLAY BUTTON Press this button to activate play mode while a tape I is loaded into the VCP. This button may also be used to disengage search and pause modes. For more information, consult the VCP owner's manual. "FFWD" FAST FORWARD BUTTON If this button is pushed while the tape is stopped, tape will fast forward. If this button is pressed while the tape is playing, the VCP will go into fast forward search mode. For more information on the search feature of the VCP, consult the VCP owner's manual. STOP BUTTON Press this button to stop the tape. REPLAY BUTTON During playback, press this button to rewind the tape to the beginning and to begin PLAY mode from there. REMOTE CONTROLLED VCP FUNCTIONS These features can only be used with a Flexvision Video Cassette Player, if this option was installed with your video package. VCP POWER BUTTON This button is used to turn the VCP on and off. "REW" REWIND BUTTON If this button is pushed while the tape the tape will rewind. If this button while the tape is playing, the VCP rewind search mode. For more consult the VCP owner's manual. is stopped, is pushed will go into information -8- CHANNEL TUNING SETUP In order to easily access all available channels, it may be necessary to perform channel auto - programming whenever the vehicle's geographic location has changed, i. e. Press the AUTO MEMORY button on the remote control unit. You will see the TV cycle through all it's channels. The built-in microprocessor will automatically store each channel that is actively broadcasting in your area. (A) To tune only stored clear channels with the CHANNEL UP/DOWN buttons, press the SKIP/SEARCH button on the Remote Control Unit until "SKIP MODE ON" is displayed on the bottom of the screen. [. . . ] These conditions may result in the following: picture roll, "snowy" picture, or momentary loss of color. Please refer to page 2 for more information on TV reception. Check the condition of the vehicle's radio antenna. Verify that the antenna is fully raised If a wired RF modulator has been installed, verify that it's switch is turned to the off position Verify +12VDC on red wire at power harness going to the video pod. [. . . ]