User manual AUDIOVOX LCM1210FD

[. . . ] 6) AP: Places the tuner in auto-program mode. Auto program will scan all channels available and store active channels into memory for easy selection with the channel up/down buttons. 7) Bright : Pressing this button will increase monitor brightness, and pressing this button will decrease monitor brightness. [. . . ] 8) Connect all components together (electrically) and verify proper operation of all system functions. NOTE: This is best done both BEFORE and AFTER all components have been permanently mounted. 9) After verifying proper operation of the system, proceed with mounting of each component. 10) When all components are mounted, recheck function of entire system again to ensure that no wiring was pinched or connected improperly during final installation. Notes: Connecting to both the Wireless Headphones IR Transmitter and an FM Modulator will require an additional RCA Adapter (P/N 0892165). One dual RCA Patch Cord is needed to connect the TV/Monitor to the Wireless Headphone IR Transmitter. One dual RCA Patch Cord is needed to connect the TV/Monitor to the FM Modulator, and is included in the FM Modulator package (P/N 0190730). For audio output, there are a few scenarios that may apply to your system: a) Remote headphone jacks may be added and located throughout the vehicle. b) Additional speakers and amplifiers may be added throughout the vehicle. 3 Vehicle Preparation: 1) Locate vehicle power source. Generally this is best found near the vehicle's fuse block, which is usually (though not always) under the steering wheel area. Locate an accessory hot circuit to tap into video system power. Accessory hot means a circuit that is +12VDC when the ignition key is in either the "ACC'Y" or "Run" positions, and 0 volts DC when the ignition key is removed from the vehicle. 2) Mounting location and method for the individual components will vary from vehicle to vehicle. This manual will only focus on the installation of the video pod itself and related console accessories. 3) Generally, the best location for the video pod itself is where the vehicle's dome light is traditionally installed (center of roof, just behind the two front seats). The pod should NEVER be located in a position that would place it within the driver's field of view. This is not only hazardous for driving conditions (as it creates a distraction to the driver), but it is against the law in many states. 4) Once the pod location has been determined, there may be prep work required for the headliner. See mounting detail below for headliner cutout dimensions and hole locations. 12. 55 11. 50 10. 65 0. 43 0. 53 0. 53 0. 75 Hinge side 2. 21 LCM1210FD Mounting Template 10. 00 6. 04 11. 25 12. 31 1. 25 2. 00 4 Wiring Diagram Hook Up Procedure: 1) Connect the power harness to the mating connector on the video pod. [. . . ] This will diminish UHF performance and may eliminate VHF reception altogether. VHF channels are 2-13 and UHF channels are 14-69. Depending on the location of the antenna and the direction of the vehicle, some VHF signal may be received. 8 Troubleshooting: Symptom: Picture scrolls or is fuzzy Poor Reception Not receiving certain channels Cause: Antenna type or location Vehicle is moving Connections Vehicle may be outside of TV signal range. [. . . ]