User manual AUDIOVOX MM530

[. . . ] If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function then the vehicle is in `park' or when the vehicle's parking brake is applied. An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied, must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle. A. Before installation, verify that it will not damage electrical wires, fuel lines, brake lines, hoses, exhaust system components or any other items that will impair the operation of the vehicle. [. . . ] NOTE: The Mounting Tray will need to be secured to the headrest, either by using tie straps, screws, etc. . . 10) Guide the cable through the side opening of the Mounting Tray and plug it into the Monitor. Make sure the connector locks into place. Insert the Monitor into the Mounting Tray and secure the cable using tie wraps or screws 11) Turn the Monitor around and insert it into the Mounting Tray housing. 12) Connect the Monitor`s DIN Cable to the external video source output signal (from VCP/DVD, TV Etc. )Test the system to verify proper installation. 7 Fan Bracket Mounting* The monitor can be mounted on a variety of surfaces using the supplied fan bracket. Select a location for the monitor and find a suitable surface to mount the fan bracket. The mounting location* should be as firm, flat and smooth as possible to ensure maximum adhesion. If the area is not flat the bracket can be bent to conform to the shape of the surface. Clean the area thoroughly and make sure that is dry before attempting to mount the bracket. Remove the backing from the adhesive pad on the bottom of the bracket and carefully place it in the desired mounting location and press down firmly. Carefully align the mounting hole on the bottom of the monitor with the screw on the top of the bracket. Release the locking lever and turn the locking knob until it is tight. Adjust the monitor angle and tighten the locking lever. Screw Screw Locking Knob Spanner Locking Lever *Note: Please read the important notice on page three about monitor location. 8 D. Controls/Indicators/Connectors: Front View 5 6 7 8 9 1. 14. DIN Jack Video (Yellow) Audio Left (White) Audio Right (Red) Red +12 VDC Black Ground 10 E. [. . . ] This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 24 MONTHS FROM DATE OF ORIGINAL PURCHASE. [. . . ]