User manual AUDIOVOX MS1701

[. . . ] Note: LCD panels may take longer to illuminate when subjected to cold temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly. The LCD display will return to normal when temperature increases to a normal range. Mode (MODE) ¶Ë Press MODE(Radio/CD Play/Aux) to select a different mode of operation as indicated on the display panel. [. . . ] When the mute feature is deactivated, the audio volume will return to the level setting in use before the mute feature was activated. Equalizer Selector (EQ ) ¶Í Press EQ to apply sound effects to the unit's audio output signal. When activated, the EQ function will access one of the following modes: CLASSICS, POP M, or ROCK M. FLAT indicates no equalizer enhancements of the program, thereby removing the preset sound effects. DSP OFF inhibits selection of equalizer mode enhancement. Reset Button ¶ The reset button is located on the front of the radio between MUTE and AS/PS. Reset should only be activated under the following circumstances: 1. Upon initial installation after all wiring is completed. 2. Upon malfunction of any switches on the unit. Use a pencil (or other non-metallic object) to press the reset button, which will clear the system and restore normal operation. Adjust Sound ¶Ó Press SEL to to step through the menu of audio functions. The first option is volume (VOL), followed by bass (BAS), treble (TRB), balance (BAL), fader (FAD), and back to volume (VOL). Band ¶Ò Press BAND to change during radio play to switch between three FM bands and one AM band. "F1", "F2", "F3", or "AM" will appear in the display momentarily to indicate which band is currently selected. frequency spacing is the default, and a switch on the bottom of the chassis allows a change to European spacing. Slide the switch to the desired setting using a small screwdriver blade, then press RESET to activate the change. Store and Recall a Station ¶Ú¶Û¶Ù¶i ¶^ ¶~ Up to 24 stations (six on each band) can be stored as presets. This radio contains special circuitry which does not require a voltage source connected to the radio to maintain memories. 1. To store a station, select the desired band and station. 2 Press and hold the desired preset button (one through six) for more than two seconds. When stored, the unit will beep, and the preset number will appear in the display. The station is now stored and can be re-called at any time by momentarily pressing the corresponding preset button. 3. Repeat for the remaining five presets on the current band and for all presets on the other bands. [. . . ] During either function, the elapsed time will appear on the display. Pause ¶Ú Press PAUSE to freeze disc play. "S--PAUSE" will appear in the display for five seconds. Scan ¶Û During disc play, press SCN to play the first 10 seconds to each track on the disc. [. . . ]