User manual AUDIOVOX PADIN4

[. . . ] Before you begin, always disconnect the battery negative terminal. Torx type, flat-head and Phillips screwdrivers Wire cutters and strippers Tools to remove existing radio (screwdriver, socket wrench set or other tools) Electrical tape Crimping tool Volt meter/test light Crimp connections 18 gauge wire for power connections 16 ­ 18 gauge speaker wire Speaker Requirements: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit. [. . . ] Select "LOW" when you are using low-level RCA radio input (RADIO LOW-IN). Pin # 1 2 3 4 5 6 7 8 9 10 11 12 1 2 3 4 5 6 1 2 Wire Color White Gray Green Violet White/Black Gray/Black Green/Black Violet/Black Orange EMPTY EMPTY White EMPTY Gray White/Black EMPTY Gray/Black Pink Red Function Driver Speaker L+ Driver Speaker R+ Passenger Speaker L+ Passenger Speaker R+ Driver Speaker LDriver Speaker RPassenger Speaker LPassenger Speaker REXT Speaker + Not Used Not Used Speaker Left + Not used Speaker Right + Speaker Left Not used Speaker Right Trigger +12V Output for DVD mode DC Input: Connect to +12 volt switched power source. The radio will not work if this wire is not connected. Power Press the POWER button or any other button on the face of the unit to turn the unit on. The DRIVER MODE icon will flash and turn from amber to green, indicating that Driver Mode was selected. The illuminated RADIO indicator will change from amber to green, indicating the selection was made. AUX 2 will change from amber to green in the display. AUX RCA Connections The RCA connections for the AUX input audio channel, labeled AUX IN 1 and AUX IN 2, are located on the back of the unit. DVD Source Button Press the DVD button to play the audio from the optional DV354 DVD player through the selected speakers. The illuminated DVD indicator will change from amber to green, indicating the selection was made. An 8-Pin DIN connector and left and right audio inputs cables allow you to control the DV354 through the PADIN4. 5mm jacks (one for AUX1 and one for AUX2) on the back of the unit in which you can plug the IR source signals. The AUX IN device can then be controlled with the AUX remote through the IR sensor on the front of the PADIN4. NOTE: If using a wireless remote with the DV354, the DV354 wired IR connection must be plugged into AUX1 IR or AUX2 IR. [. . . ] La alimentación no va a la unidad Ninguno de los altoparlantes funciona (las luces del visualizador funcionan) No todos los altoparlantes funcionan Does not operate (display No power to yellow wire does not light) No power to red wire Inline fuse blown No power to unit No speakers operate Inline fuse blown Speaker harness not connected Incorrect splices or connections Speaker wires shorting to Check splices and chassis ground or to each connections. Other Blows fuses Power wire shorting to ground Make sure wire is not pinched. Speaker wires shorting to Make sure wire is not ground pinched. [. . . ]