User manual AUDIOVOX SP-11CDP

[. . . ] To remedy the situation, remove the discs from the unit and wait approximately one hour. During this time the moisture will evaporate and the unit will operate normally. INTERRUPTIONS IN SOUND (Skipping) The sound from the unit may "skip" and be interrupted if the anti-vibration springs are not set correctly, if the changer is mounted on-end or upside-down, or when travelling on very rough road surfaces. If this should occur, check for errors made during installation or wait for the road surface to improve. [. . . ] Push the tray back into the magazine as shown in Figure 3. Load discs into the remaining 9 trays in a similar manner. REMOVING DISCS FROM THE MAGAZINE To remove a disc from the magazine, pull out the tray of the disc to be removed, lift out the disc, and push the tray back into the magazine. NOTES: l Avoid touching the playing side of the disc. l Only one disc can be inserted into each tray of the magazine. Do not try to insert more than one disc into each tray as damage to the discs and magazine may occur. l This changer is not designed to play 3" CD-Single discs (8cm). Inserting a 3" disc into the magazine, either with or without a 3" disc adaptor, can damage the changer and the disc. Such damage will not be covered by the Warranty on this product. l Additional CD magazines are available as accessory item part number SP11M from your Audiovox dealer, or you may contact us directly at: Attention: Parts Division Audiovox Corporation 150 Marcus Blvd. , Hauppauge, NY 11788 www. Audiovox. com and/or 1-800-645-4994 Fig. 2 Label side up Play side down Fig. 3 3 LOADING THE MAGAZINE INTO THE CHANGER Completely slide the door on the changer to the right as shown in Figure 4. Making sure the top of the magazine is facing upward, gently insert it into the unit until it clicks into place, as shown in Figure 5. Slide the door of the changer fully closed and the unit is ready for operation. REMOVING THE MAGAZINE FROM THE CHANGER The magazine can be removed from the changer using one of two methods as outlined below in steps a and b. NOTE: Be sure to keep the door on the changer closed at all times when not loading or removing the magazine. Leaving the door open could allow dust, dirt and moisture to enter the changer which could cause the unit to malfunction. During normal operation with power applied, slide open the door on the changer and press the eject button as shown in Figure 6. The magazine will eject and can be removed. If the magazine will not eject in a normal manner, remove power by disconnecting the DIN cable from the changer. At the lower left rear of the changer, as shown in Figure 6, insert a thin-bladed screwdriver straight into the access hole about 1-1/2 inches until it contacts the release tab. Lightly leverage the blade to the right and the magazine will disengage and be ejected. Fig. [. . . ] THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 48 MONTHS FROM DATE OF ORIGINAL PURCHASE. [. . . ]