User manual AUDIOVOX VBP3000

[. . . ] VBP3000 VIDEO IN A BAG SYSTEM WITH DETACHABLE 5" LCD TV/MONITOR AND VIDEO CASSETTE PLAYER A. Introduction Thank you for selecting this "Video in a Bag" System. The system's main features include two 5" Liquid Crystal Display (LCD) TV/Monitors and Video Cassette Player (VCP) (see page 4 for a detailed feature list). The system utilizes the latest state of the art electronics and is designed for use in vehicles, hotels, offices or your home. [. . . ] Adjust the zippers so that the unit is at the proper angle to allow the screen to be adjusted for the best viewing angle. 7 6 Option 2 (Refer to Figure 8) Figure 8 1. Follow the installation instructions shown in the Option 1. Remove the second monitor and its pouch from the front compartment of the bag. Unfastening the Velcro strap and remove the monitor from the pouch. Rotate the base of the second monitor backward so that it may be placed in an upright position on a flat surface. Insert one end of the DIN cable into the MONITOR PORT on the side of the detached monitor, slide the cable through the slot in the bag, and insert the other end into the MONITOR PORT on rear of the main unit. 8 Option 3 (Refer to Figure 9) Figure 9 1. Follow the installation instructions shown in the Option 1. Remove the additional monitor and pouch from the front compartment of the bag, make sure to feed the bottom piece of the pouch into the long slot of the Monitor and attach the Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around the headrest and pull the end of the strap while holding the buckle until the pouch is tightly secured. Insert one end of the DIN cable into the MONITOR PORT on the left right side of the detached monitor, slide the cable through the slot in the bag and insert the other end into the MONITOR PORT on rear of the main unit. 9 I. Installing the Unit with Bag on the Back Seat in a Car There is no need to remove the four straps from the bag as they are not used in this installation. Option 1 (Refer to Figure 10). Figure 10 Carefully place the system (back facing up) on the back seat. Guide the vehicles safety belt through the short strap sewn on the front of the bag. Then secure and adjust the safety belt so that the unit is not free to move around. Finally uncover the attached monitor and adjust the screen for a desired viewing angle. Option 2 (Refer to Figure 11) Figure 11 1. Follow the installation instruction shown in the Option 1. Detach the monitor from the system by depressing the button below the screen with one hand and removing the monitor with the other. Slide the monitor into the spare monitor pouch, feed the bottom piece of the pouch into the long slot of the monitor, and attach the Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around the headrest, and pull the end of the strap when holding the buckle until the pouch is tightly secured. 10 3. Remove the additional monitorand pouch from the front compartment of the bag, making sure to feed the bottom piece of the pouch into the long slot of the monitor and attach the Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around the headrest of the same row, and pull the end of the strap when holding the buckle until the pouch is tightly secured. Insert one end of the DIN cable into the MONITOR PORT on the side of the detached monitor. Slide the cable through the slot in the bag and insert the other end into the MONITOR PORT on rear of the main unit. [. . . ] 180 Minutes with T-180 Set to the SP Mode Fast/Forward/Rewind Time: . . . . . . . . . Less than 7 Minutes with T-120 Video Output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 0 Vp/p, 75 Ohm, unbalanced Video S/N: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Better than 35 dB Audio Output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]