User manual AUDIOVOX VE-640

[. . . ] Installation and Operation Manual VE-640 Low Profile Television 6. 4" LCD Drop Down Under Counter TV / Video Monitor SEEK CH TV FM/AM ON/OFF A/V TEL TV FM/AM AM PM CH 1 CH 2 CH 3 SET CH 1 CH 2 CH 3 VOL AUDIOVOX FEATURES n n n n n n Multi-Function Remote Control Built-In Telephone Mode Cable Ready 125 Channel Tuner Internal Stereo Speakers Under Cabinet Mounting A/V Input -1- Addendum to the Installation and Operation Manual VE640 Low Profile Television 6. 4" LCD Drop Down Under Counter TV / Video Monitor The purpose of this Addendum is to replace the "SETTING ALARM" procedure found in the Operation section of the VE-640 Operation and Installation Manual (Pg. 13). SETTING and ACTIVATING ALARM NOTE: The VE640 must be turned "OFF" when performing the following procedure. 1) Press the SET button (1) twice to enter the alarm mode. The five LED indicators (2) on either side of the LCD-Display will begin flashing. [. . . ] 8) CH 3 INDICATOR-When illuminated, the VE-640 is tuned to the preset channel 3. 9) SET-Press this button to set the time, alarm, and the FM/AM broadcast. 10) SEEK UP BUTTON-Press this button for the next higher available channel with sufficient signal strength. 11) SEEK DOWN BUTTON-Press this button for the next lower available channel with sufficient signal strength. 12) UP&DOWN CH-BUTTONS-Press these buttons to increase or decrease the channel to view a specific channel. 13) UP & DOWN (VOL) BUTTON-Press these buttons to increase, or decrease the volume level. -6- 14) CH3-BUTTON-Press this button to view the third user programmed channel. 15) CH2-BUTTON-Press this button to view the second user programmed channel. 16) CH1-BUTTON-Press this button to view the first user programmed channel. 18) Microphone- For hands-free speaker phone operation. 19) TELEPHONE BUTTON (TEL)-Pressing this button allows the user to answer an incoming call. (The VE-640 contains hands free speakerphone). 20) AUDIO-VIDEO BUTTON (AV)-Press this button to view an external A/V source that is plugged into the rear A/V jacks. 21) CONTRAST CONTROL- This control (located on the side of the LCD) adjusts the picture contrast. 22) COLOR CONTROL- This control (located on the side of the LCD) adjusts the color level of the picture. 23) BRIGHTNESS CONTROL-This control (located on the side of the LCD) adjusts the brightness of the picture. 24) ON/OFF BUTTON-Press this button to turn the VE-640 ON and OFF. 25) TV BUTTON-Press this button to have the VE-640 to switch back to TV mode. 26) FM/AM BUTTON- Allows user to set the VE-640 to receive AM or FM radio broadcasts. REAR PANEL CONNECTIONS AM-ANT. AUDIO-IN VIDEO-IN 5) 1) FM ANTENNA- Allows the VE-640 to be connected to an external antenna for the 6) reception of FM broadcast signals. 2) 75 OHM ANTENNA CONNECTOR 7) Allows the VE-640 to be connected to a 75 ohm external coaxial antenna. 3) AUDIO INPUT-RIGHT-Connect to right audio 8) output from external A/V source. 4) AUDIO INPUT-LEFT-Connect to left audio output from external A/V source. VIDEO INPUT-Connect to the video output from external A/V source. [. . . ] Pressing the power button on the TV or the remote will turn the system on or off. Remember to turn the unit off and pivot the screen to the closed position when not in use. SETTING THE TIME NOTE:All settings will be performed with the VE-640 turned off. 1) Press the SET button and the minutes will flash. 2) Use the channel up and down button to set the minutes. [. . . ]