User manual AUDIOVOX VE700

[. . . ] · · · · · · · Multi-function Remote Control Built-in Hands Free Speaker Phone Cable Ready 125 Channel TV Tuner Internal Stereo Speakers Under Cabinet / Table Top Mounting A/V Input AM/FM Radio Tuner -1- INTRODUCTION WARNING ­ To prevent fire or shock hazard, do not expose this unit to moisture. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR TO BACK). USERREFER SERVICE SERVICEABLE SERVICING PERSONNEL. CAUT ION QUALIFIED This symbol is intended to alert the user to the presence of uninsured "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. TO PREVENT ELECTRIC SHOCK: DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. -2- INFORMATION This equipment generates and uses radio frequency energy and if not installed and used property, that is, in strict accordance with the manufacture's instructions, may cause interference to radio and found to not comply with the limited for a Class B computing device in accordance with the specifications in Subpart J of Part 15 or FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] c) If the unit has been dropped or the cabinet has been damaged. - Cable System Installation: Note to CATV system installer: "This reminder is provided to call the CATV (CABLE-TV) system installer's attention to article 820-40 of the NEC, that provides guidelines for proper grounding and, in particular, specified that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical" - Under cabinet mounting: " CAUTION: to reduce the risk of fire, do not place any heating or cooking product beneath this unit" -7- CONTENTS OF PACKAGE PW R TEL TV VO L C H EN T CH VO L A /V M UTE SEEK F M /A M 1 4 7 2 5 8 3 ERA SE 6 9 ADD 0 1. Manual -8- UNDER CABINET INSTALLATION 1) Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an electrical outlet, a TV antenna or cable connection and a telephone jack will facilitate a neat, easy installation. Do not mount the VE700 above a range or oven. Be sure that the location chosen will provide adequate access to the electrical connection on the rear of the unit before continuing. 2) If the location chosen has bottom edge molding it may be necessary to use the mounting spacers provided to effectively lower the VE700 below or even with the molding. Measure the distance between the bottom and the bottom of the cabinet. For large molding choose a combination of spacers which will allow the VE700 to be secured to the bottom of the cabinet. 3) Measure the thickness of the bottom of the cabinet or shelf and the spacers chosen. Select the shortest screw length, which will secure the VE700 to the bottom of the cabinet. 4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center punch the four holes indicated on the template and remove the template. 5) Carefully drill four 1/8 holes at the locations marked above. Place the screws selected through the VE700 and then through the spacers (if required from the bottom-up) 6) Position the VE700 and mount it in place using the selected screws. 7) Connect your TV antenna or cable system to the antenna connector on the rear of the VE700. 8) Attach the FM Dipole Antenna to the FM Antenna screws and position the antenna for the best reception. 9) If using the speakerphone feature, plug the VE700 into a phone jack. 10) Plug the AC power cable into the wall outlet. Press this button For a half second to active a AUTO PROGRAM. 12) Remote Infrared sensor-This sensor receives infrared signals from the hand held remote control unit. 13) LCD Display ­ Displays the channel number, AM/FM frequencies, the time of day and auxiliary input. 14) SEEK ­ Press this button for the next available channel with sufficient signal strength. [. . . ] 2) Press the CH up/down buttons to set the desired hour/minute. When setting the check the AM/PM indicator to assure the proper setting. 3) Press the SEEK buttons to toggle between the hours and minutes. 4) Press the ON/OFF button or T/F button. [. . . ]