User manual AUDIOVOX VME 9312 TS DATASHEET

[. . . ] 9 Care and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 OPERATING INSTRUCTIONS 1 ON-OFF POWER BUTTONon or off. The unit will also turn 3 SELECT BUTTON (SEL) Press this button to turn the unit DISPLAY CLOCK on automatically when a cassette tape is inserted if the ignition switch is "on". 2increase the volume level, press the/ VOL-) +" side of the VOLUME LEVEL CONTROL (VOL+ To "VOL button. [. . . ] Pressing and holding the button again for two seconds will select the Distant setting ("LOC" will disappear from the display panel) and the radio will stop at a wider range of signals, including weaker (more distant) stations. -3- STATION PRE-SET MEMORIES To set any of the 6 pre-set memories in each band, use the following procedure: 1. Turn the radio on and select the desired band. Select the first station to be pre-set using the Manual Up/Down or Automatic Seek Tuning Controls . Press the pre-set button to be set and continue to hold it in. After approximately 2 seconds, the display will flash, the volume will be momentarily muted and the pre-set button number (P1, P2, etc. ) will momentarily appear on the display panel indicating that the station is now set into that pre-set memory position. The station can now be recalled at any time by pressing that button. Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 2 bands on the unit. bn bp CASSETTE DOORthe exposed tape edge to the right and Hold the cassette with insert it into the cassette door. Depress fully until the cassette is engaged and begins playing as shown by the tape direction indication on the display panel. When the cassette reaches the end on the side of the tape being played, the unit will automatically change direction of play as shown by the direction arrow and play the other side of the cassette. NOTE: Observe cassette operation Cautions in the Care and Maintenance section of this manual. 9 bq FAST-FORWARD BUTTONwill cause the tape to move rapidly (FF) Pushing the Fast-Forward button in the forward direction of play (tape direction arrow on display panel will flash). To stop Fast-Forward movement, lightly push the Rewind Button until the Fast-Forward button disengages. bo LIQUIDCrystal Display (LCD)PANELdisplays the frequency, CRYSTAL DISPLAY The Liquid panel time, and activated functions. Press and hold the Select button approximately 4 seconds until the time display begins flashing. While the time display is still flashing, press the Volume button ( + ) to adjust the hours and the Volume button ( ­ ) to adjust the minutes to the correct time. When the correct time is shown on the display panel, press the Select button again to return to normal display. 3 3 -6- CD CHANGER CONTROLS Built into this unit are controls to operate an optional CD changer. Please check with your Prestige car stereo specialist for recommendations of the models that will work with this unit. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio and cassette play. The following controls will operate the CD changer when it is installed and connected to this unit. Refer to the owner's manual included with the CD changer for instructions on the installation and correct loading and use of the CD magazine. Backward Track Select button (TRK­), the next lower track number will be selected. High-speed audible search to any section of the disc can be made by the Cue and Review functions. Press and hold the TRK+ button to advance rapidly in the forward direction or the TRK­ button to advance rapidly in the reverse direction. During either function, the elapsed time within each track will automatically be shown on the display panel. The Track Select button cp will also select tracks in the shuffled order instead of the normal progression. When all tracks on the disc have been played in shuffled order, the next disc will be selected in normal order and its tracks played in shuffled order. [. . . ] As with any cassette player, the cassette section of this sound system does require a minimum of maintenance to keep it in good working condition. The following simple care and maintenance suggestions should be followed to prevent malfunctions of the cassette system. Purchase a cassette cleaning kit from your local retail store. At least every 20 to 30 hours of operation you must clean the cassette mechanism. [. . . ]