User manual AUDIOVOX XMB10

[. . . ] Xpress Satellite Radio Receiver ® XMB10 Boom Box User Guide -1- Released 9-15-05. 128-7546 1 of 16 CONTENTS Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 FCC Regulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Cautions and Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Contents XMB10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When using the AUX audio input, turn the Receiver off to preserve battery power. Adjust the volume level of the external audio device to obtain an audio output from the XMB10. The volume control on theexternal audio device should be set to mid-range. VOLUME +/- Pushbuttons: Increase or decrease the volume of the audio output signal from the XMB10. To increase the 6 volume level, press the + pushbutton; to decrease the volume level, press the - pushbutton. 1 2 3 4 5 NOTE: The Volume buttons on the Remote Control unit (included w/Receiver Combo) will also control the volume output of the Boom Box. Power On/Status/Low Battery LED: The LED lights blue when the Power On/Off pushbutton is pressed to apply power to the XMB10. When operating on AC current, the LED will briefly flash approximately every 10 seconds. When operating on DC(batteries) current, the LED will briefly flash approximately every 5 seconds. The LED will also indicate the status of the volume pushbuttons when the AUX Jack is in use; the LED will flash each time the Volume + or button is pressed until the maximum setting is reached in either direction. Then the LED will resume power source flashing as before. Power On/Off Switch: When pressed, applies power to the Boom Box; the power on LED indicator (4) lights blue. EJECT Button: Press this button to release the spring-loaded XMB10 mounting plate to install and remove the Xpress® Receiver from the Boom Box. -6- 128-7546 6 of 16 1. Battery Installation Your Boom Box can operate independently of AC power by installing 8 C-Cell batteries as follows: NOTE: The batteries are bypassed automatically whenever the supplied AC Adapter is plugged into the DC 12V jack on the back panel. COVER LATCHES BATTERY COMPARTMENT COVER NEGATIVE BATTERY COMPARTMENT (COVER REMOVED) POSITIVE NEGATIVE BOTTOM OF BOOM BOX 2. Cabling Interconnections You can begin to enjoy Xpress XM® Satellite Radio as soon as the Receiver and Boom Box Kit installation are complete. Set up your Audiovox XMB10 by following theinterconnect diagram. Installing the Receiver in the XMB10 Install the receiver as follows: IMPORTANT: Make sure boom box power is off before installing and removing the Xpress Receiver. Press the EJECT button at the top of the XMB10; the spring-loaded mounting plate will tilt forward. RECEIVER COMPARTMENT MOUNTING PLATE EJECT BUTTON MOUNTING PLATE DETENT POSITIVE 1. Turn the Boom Box upside down to access the battery compartment. Push the battery cover latches forward and flip up the battery compartment cover to the open position. Insert eight (8) C-Cell batteries observing battery polarity as shown; then close the cover. CONNECTOR GUIDE PIN Xpress RECEIVER CONNECTOR -7- 128-7546 7 of 16 b. [. . . ] (3. 06Kg) -12- 128-7546 12 of 16 Maintenance Periodic Inspection The XMB10 Boom Box should be inspected periodically for external damage. At least once every 30 days of use, perform the following checks: 1. Inspect the Receiver connector for loose, bent or broken pins, misalignment, etc. ; make sure the Xpress Receiver connector is intact and exhibits no apparent damage. Check the VOL control for freedom of motion without binding of any kind. [. . . ]