User manual AUTOTECH 10.202.401K-404K

[. . . ] Installation Instructions Part Number: 10. 202. 401-404K Description: COLD AIR INTAKE SYSTEM, Mk4 Tools Required: 10mm. [. . . ] Remove battery cover Remove battery hold down clamp Remove plastic retainers on top of the battery Disconnect battery terminals (always disconnect ground first) Remove battery Using a 10mm. socket, remove the two bolts holding down the airbox Remove the four bolts holding down battery tray Remove battery tray Using a short Phillips screwdriver, remove the two screws used to attach the mass air meter. Disconnect breather hose from airbox Remove airbox Using 10mm. socket, remove the nut holding the ducting tube (nut will be re-used) Using a phillips screwdriver, remove the ducting behind the driver's side headlight Remove the three plastic pushpin connectors on the remaining ducting Remove ducting With a small file or rotary sanding drum, clearance some of the plastic flange at the rear of the headlight to make room for the massive 3" tube Install air inlet tube Install silicone hose between the inlet tube and the airflow meter and tighten the supplied hose clamps Install the nut on the body stud protuding through the bracket on the air inlet tube Install the air filter from underneath Re-install the battery tray Re install the battery Re-connect the battery leads (always connect ground last) Re-attach the battery hold down Re install the battery top covers and engine cover Install the breather tube connector between air inlet tube and factory breather piping (pinch connectors to clip over nipples 1. Using a 10mm socket, remove the. . . . . . . two bolts holding down the airbox 7. Remove the four bolts holding down the battery tray 9. . . . remove the ducting (nut will be reused) 13. . . . remove ducting behind headlight 16. [. . . ] Install breather tube connector Completed installation [. . . ]