Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AUTOTECH 10.215.340 351 361. We hope that this AUTOTECH 10.215.340 351 361 user guide will be useful to you.
Lastmanuals help download the user guide AUTOTECH 10.215.340 351 361.
Manual abstract: user guide AUTOTECH 10.215.340 351 361
Detailed instructions for use are in the User's Guide.
[. . . ] A
U
T
O
T
E
C
H
Installation Instructions
Part Number: 10. 215. 340xx-10. 215. 351xx, 10. 215. 361xx Description: Autotech Q-Chip Thank you for purchasing an Autotech Q-chip. Please read the installation procedure listed below as it will save you time (and possibly parts) in the long run. [. . . ] This will push the entire connector out as it rides on pins on the ECU. Separate the control unit from the frame by removing the large Phillips head screws holding the control unit to the frame and slide the control unit from the frame. To open the control unit, use a Phillips screwdriver or a Torx driver (depends on control unit) to remove the four screws at the connector end, (and at the heat sink end on KE-Motronic) and slide the electrical section out from the black outer casing. The chip that you will be replacing will be the only one set into a socket, and will usually have a white "H" shaped plastic retainer covering it. If you do not see any socketed chips, call Autotech before proceeding any further. Before removing the stock chip, take note of the location of the notch at the top of the chip. It is mandatory that the Qchip be installed in exactly the same position!If you install the Q-chip backwards, you will damage your control unit as well as the Q-chip. Remove the stock chip by first removing the white retaining clip, then gently pry out the chip from the socket, using a small screwdriver between the two. To prevent bending the pins, change sides often until the chip is completely removed. Autotech will not be responsible for chips with pin damage.
Note notch or dot.
Note: The socket should also have a corresponding notch or dot to aid in correct alignment. Insert the Q-chip into the socket only after you have double-checked that it is in the same position as the original. [. . . ] This is a normal characteristic after changing chips. A short drive will provide new adaptive memory information, and will smooth out the idle.
32240-E Paseo Adelanto, San Juan Capistrano, CA 92675 Phone 714. 240. 4000 Fax 714. 240. 0450 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE AUTOTECH 10.215.340 351 361
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AUTOTECH 10.215.340 351 361 will begin.
