User manual AUTOTECH 10.297.220K-222K

[. . . ] A U T O T E C H Installation Instructions Part Number: 10. 297. 220K; 10. 297. 222K Description: SPORTTUNED ALUMINIZED EXHAUST SYSTEM, A3 4-cylinder 1993-98 Notes: This AUTOTECH exhaust for Golf and Jetta 3 vehicles is patterned after the 1996 and later factory design, using a single over-tube hanger just ahead of the midmuffler. 1993-95 cars with a dual hanger design are converted to the later, single hanger style using the hanger (1H0. 253. 144C) supplied with the Autotech exhaust. [. . . ] Loosen the clamp bolts and slide clamps off the joints. Before installing the AUTOTECH system, first lay out all the components on the ground to familiarlize yourself with their installed orientation. Remove the old exhaust system, starting from the rear of the car and working your way forward. Start with the front pipe that slips onto the catalytic convertor, and work your way back. Be sure to install all the components loosely, so that you can rotate or adjust any pieces if necessary, for proper fit and alignment. Of the 5 clamps supplied, 3 have the tubular hangers welded on. Note positions below: 144A 144B Drain Hole should be at 6 O'clock Position on back of rear muffler. 144C 32240-E Paseo Adelanto, San Juan Capistrano, CA 92675 Phone 949. 240. 4000 Fax 949. 240. 0450 front > b a Fig 1. Right side view of midpipe hanger (a) and clamp installed. The supplied rubber hanger (b) bolts to the car in place of the dual hanger assembly found on 1993-95 vehicles. Hook in foreground is not used on the A3. Fig 2. [. . . ] Note the position of the drain hole on the back plate of the muffler. This shows the rotation of the rear muffler for best fitment. 32240-E Paseo Adelanto, San Juan Capistrano, CA 92675 Phone 949. 240. 4000 Fax 949. 240. 0450 [. . . ]