User manual AUTOTECH 10.425.1825GK

[. . . ] Installation Instructions Part Number: 10. 425. 1825K Description: Kit includes: 1pc. Powdercoated swaybar bushing brackets w/ nuts 2pcs. [. . . ] Raise front of car with floorjack and place jackstands under car using factory lifting and support locations. Remove the nuts that attach the end-links to the factory swaybar. Loosen and remove the bolts from the aluminum sub-frame that have a 13mm. (swaybar bracket bolts and rack-n-pinion bolts) (13mm. Remove both bolts retaining the lower transmission "Dog Bone" mount. head bolts from subframe and a-arm mounts (21mm. head bolts while supporting the subframe. Once the bolts are removed, the a-arm assemblies and rack-n-pinion will be hanging loose, so BE CAREFULL!Grease the inside of the Autotech supplied bushings and slide them onto your new swaybar. Attach swaybar endlinks to new swaybar with the nuts finger tight. (diagram 2/ adjustment chart) Softest Middle Stiffeset 1 Swing swaybar up near rack-n-pinion and re-install the lower subframe in the reverse order of steps 3 1. Install the supplied Autotech swaybar brackets and spacers 13. [. . . ] Lower vehicle back onto ground and take car for a test drive. 1L 2L 2L 4L 3L 3R 2R 2R 4R 1R 5L 4L 7L 5L 6L 9 5R 4R 5R 6R 7R 8L 10A 8R 10B Num. 1 2 3 4 5 6 7 8 9 10A 10B Figure 1 L/R/Center L/ L/ L/ L/ L/ L/ L/ L/ C C C R R R R R R R R Bolt Size M12 x 1. 5 x100 M12 x 1. 5 x90 M10 x 1. 5 x76 M12 x 1. 5 x90 M8 x 1. 25 x80 M12 x 1. 5 x90 M12 x 1. 5 x75 M12 x 1. 75 x1 10 M14 x 1. 75 x70 M10 x 1. 75 x35 M10 x 1. 75 x75 Figure 2 Tourque Value 52lbs + (90deg. ) 52lbs + (90deg. ) 37lbs + (90deg. ) 52lbs + (90deg. ) 15lbs + (90deg. ) 52lbs + (90deg. ) 52lbs + (90deg. ) Front Lower A-arm Bolt Dog-Bone Mount to Subframe bolt 44lbs. [. . . ]