User manual AVANTI 248YW

[. . . ] We have provided many important safety messages in this manual for your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words" DANGER", "WARNING" or "CAUTION". Danger means that failure to heed this safety statement may result in severe personal injury or death. Warning means that failure to heed this safety statement may result in extensive product damage, serious personal injury, or death. Caution means that failure to heed this safety statement may result in minor or moderate personal injury, property or equipment damage. [. . . ] If the power cord is damaged, have it replaced by an authorized Avanti Products service center. This unit should be properly grounded for your safety. The power cord of this unit is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This unit requires a standard 115/120 Volt AC ~/60Hz electrical outlet with three-prong ground. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. The cord should be secured behind the unit and not left exposed or dangling to prevent accidental injury. How to Choose the Celsius or Fahrenheit Degree?You can select temperature display setting from Fahrenheit to Celsius degrees by pushing the button marked °C and then Celsius degrees indicator will be ON or select temperature display setting from Celsius to Fahrenheit degrees by pushing the button marked °F and Fahrenheit degrees indicator will be ON. Interior Light You can turn the interior light on or off by pushing the button marked " " symbol. The light will be turned off automatically if it remains ON for 15 minutes. Also protect outside of Wine/Beverage Cooler with a blanket, or similar item. The Wine/Beverage Cooler should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight. 12 PROBLEMS WITH YOUR WINE/BEVERAGE COOLER? You can solve many common Wine/Beverage Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBL EM Wine/Beverage Cooler does not operate. Wine/Beverage Cooler is not cold enough. The circuit breaker tripped or a blown fuse. External environment may require a higher setting. The Wine/Beverage Cooler does not have the correct clearances. The room temperature is hotter than normal. The temperature control is not set correctly. The Wine/Beverage Cooler does not have the correct clearances. Check to assure that the Wine/Beverage Cooler is level. [. . . ] Para evitar vibraciones, la caja debe estar bien nivelada. Al conectar su vinera por prim era vez, puede haber una variante de varios grados entre la temperatura seleccionada y la indicada en la activación y desactivación . También hay una variante de 6º a 8º C entre los estantes superiores e inferiores de la vinera, de forma que si usted quiere combinar una mezcla de vinos rojos (tintos) y blancos, deberá colocar las botellas de vino blanco en el estante inferior y las de vino tinto en el estante superior . Si usted ha programado el enfriador de vino a 15ºC por ejemplo, podría aumentarlo oprimiendo el botón marcado sucesivamente o podría bajarlo oprimiendo el botòn marcado . También puede cambiar de grados centígrados a Fahrenheit, oprimiendo el botón marcardo C/F. Fº aparecerá en la pantalla de color rojo, Cº aparecerá en la pantalla de color amarillo. [. . . ]