User manual AVANTI WC492D

[. . . ] We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages . This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words " DAN GER", "WARNING" or "CAUTION". Danger means that failure to heed this safety statement may result in severe personal injury or death. Warning means that failure to heed this safety statement may result in extensive product damage, serious personal injury, or death. Caution means that failure to heed this safety statement may result in minor or moderate personal injury, or property or equipment damage. [. . . ] The temperature that you desire to set will increase 1ºF or 1ºC if you push the UP button once, on the contrary the temperature will decrease 1ºF or 1ºC if you push the DOWN button once. When you store mostly red wines, the temperature which you control by pushing the above two buttons need to be set at between 58 to 65?F and the LED lamp under "RED" will be lit red. When you store mostly white wines, the temperature needs to be set at between 48 to 57?F and the LED lamp under "WHITE" will be lit green. When you store mostly sparkling wines, the temperature needs to be set at between 40 to 47?F and the LED lamp under "SPARKL" will be lit amber. You can select temperature display setting from Fahrenheit to Celsius degree by pushing the UP and DOWN button at the same time for 5 seconds . Fahrenheit and Celsius degrees indicator will appear in green color in the "SET" window. The temperature inside the unit will appear in red color in the "DISPLAY" window. If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. For easy access to the bottles, you must pull the shelves approximately 1/3 out of the rail compartment. 13 ? To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat screwdriver to press down the right plastic notch as shown in Figure A and at the same time lift the left plastic notch as shown in Figure B. Then proceed to pull out the shelf slowly. Contact our service department if assistance is needed. Figure A Figure B 14 CARE AND MAINTENANCE ?Turn off the power, unplug the appliance, and remove all items including shelves and rack. Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts. Wash the outside cabinet with warm water and mild liquid detergent. [. . . ] También puede cambiar de grados centígrados a Fahrenheit, oprimiendo los botones marcados UP y DOWN sucesivamente y aparecerán en la pantalla marcada "SET" en color verde. La temperatura dentro de la unidad aparecerá en la ventana marcada "display". Luz interior La luz interior se controla manualmente y no funciona al abrir ni cerrar la puerta. Para prender o apagar la luz, presione el boton marcado ( ) de la luz ubicado en el panel de control. [. . . ]