User manual AVDEL 07537

[. . . ] LIMITED WARRANTY Avdel makes the limited warranty that its products will be free of defects in workmanship and materials which occur under normal operating conditions. This Limited Warranty is contingent upon: (1) the product being installed, maintained and operated in accordance with product literature and instructions, and (2) confirmation by Avdel of such defect, upon inspection and testing. Avdel makes the foregoing limited warranty for a period of twelve (12) months following Avdel's delivery of the product to the direct purchaser from Avdel. In the event of any breach of the foregoing warranty, the sole remedy shall be to return the defective Goods for replacement or refund for the purchase price at Avdel's option. [. . . ] It identifies both the mandrel and mandrel follower spring required for a particular nose jaw with a specific fastener. # These nose jaws are suitable for placing Chobert® rivets with a Universal Head Form. When used on the equivalent size of Briv®, the highest possible clench is achieved. # These nose jaws are suitable for placing Chobert® rivets with a Universal Head Form. When used on the equivalent size of Briv®, the highest possible clench is achieved. Mandrels and mandrel follower springs, illustrated on page 11 need to be selected to suit the fastener type and size as well as the size of the hole in the application. Use of the wrong mandrel could increase the risk of breakage and the wear of the mandrel head. To find the correct part number of a mandrel for a particular application, read the instructions below after you have gathered the following information as per example alongside. Turn to the page with the `Mandrel Selection' table for your fastener, selecting either the imperial or the metric dimensions table (pages 16-20). Staring with the `Standard Mandrel - Green' section, find your fastener size in the left-hand column. If you selected a nose jaw which place you fastener, you should now be able to find a line within your fastener section with the same `Ref No. ' in which you will find both your mandrel and mandrel follower spring part number. This line continues into the second half of the table for the `2nd' and `3rd' oversize mandrels. Scan along the line to the `hole size' columns and select which ever is the nearest or equal to the figure calculated in step one. You may now read the mandrel part number next to the `hole size'. -example: 07150-06104 · For Chobert® and Grovit® only, most mandrels are also available in a `short reach' version (see illustration on page 19). Short reach mandrels are used to minimise the possibility of the mandrel head contacting an obstruction. This would result in the underside of the fastener head not seating properly on the application surface, causing a lack on clench in the joint. Whichever size mandrel you settle on, you will also need to check the `P' figure against that mandrel is adequate. `P' is the clearance required for the mandrel head at the back of the application IN ADDITION to the length of the fastener protruding through the application, as shown in the illustration on page 19. You may now read the corresponding mandrel follower spring part number in the right-hand column of the table. In all cases, satisfactory clenching of the joint should be assessed particularly if the size of the hole in your application is very close to the next oversize hole condition, when it will be safe to select the greater size of mandrel to obtain a higher clench. [. . . ] Clean and oil Mechanical Cursor 36 occasionally with a little light oil. Item numbers in bold refer to the general assemblies and parts lists on pages 26-27. It may also be necessary to restore the full stroke after considerable use, when the stroke may be reduced and fasteners are not fully placed by one operation of the trigger. 5l (part number 07992-00002) or one gallon containers (part number 07992-00006). [. . . ]