User manual AVDEL TX2000

[. . . ] 4 The tool shall at all times be operated in accordance with the relevant health and safety legislation. Any question regarding the correct operation of the tool and operator safety should be directed to your local Avdel UK Limited company or authorized representative. 5 6 7 8 9 Do not operate a tool that is pointed towards any person(s). ensure that vent holes do not become blocked or covered. [. . . ] Remove the battery from the charger and allow it to cool before trying again. This will occur when the battery temperature is above 65°C and can result if the battery is inserted directly after charging or discharging. If the RH LED shows SOLID RED this indicates that the battery is faulty. remove Battery from the charger and do not use. Removing the battery at this point will increase the service life of the battery. At this point the battery will be trickle charged until removed. When charging a Ni-MH battery the RH LED can be seen to FLASH RED & GREEN. To achieve the optimum performance from the battery, please adhere to the following guidelines when charging: Aim to charge when both the battery and charger are cool. A new battery will only reach full capacity after several charges. To increase the service life of the battery, remove from the charger when the RH LED shows solid yellow. To increase the service life of the battery, only re-charge when no further fasteners can be placed. To achieve the maximum number of cycles from a battery use directly after charging. Batteries must only be charged using the Avdel® charger supplied. Optimum life is achieved when used at 22°C. The battery will reach its full capacity only after several charges. The surrounding temperature must not exceed 50°C (122°F) or be below -40°C (-40°F) For optimum life and performance only re-charge the battery when no further For optimum performance use the battery directly after re-charging. Significantly reduced operating time of the battery after a complete re-charge Store the battery in a frost free and dry environment. To ensure that the batteries are disposed of correctly please return to an authorized Used batteries must not get into waste, fire or water under any circumstance. A complete tool includes the nose assembly kit 71210-15100 with the following three Nose tips as standard: 71210-05002, 71210-16070 and 07381-04701 (Please refer to page 7 for details of the range of fasteners they will place). Nose tip 07381-04701 is supplied fitted to the nose assembly and the other two are screwed into the front end of the tool. It is important that you check that the nose tip already fitted to the nose assembly is The correct one to place your fastener by sliding the fastener stem into the nose tip. No force should be required and play should be minimal. [. . . ] Air bubbles will be visibly expelled from the reservoir inlet point, position 2, into the priming pump. Release the trigger allowing the piston to return and air bubbles to be expelled into the priming pump. Repeat this procedure until no further air bubbles are expelled into the priming pump. Allow several seconds between each cycle so that the air bubbles have time to collect in the priming pump. [. . . ]