User manual AVERMEDIA AVERTV BOX9

[. . . ] To turn off /on the sound To call up the menu display - Go to the next or previous TV channel line up - Use these buttons to make the selection in the menu or picture setting - Switch the audio source from the AVerTV Box9 when in PC display mode - Switch between the available display resolution settings when in TV/Video mode Turn the unit on/off If the channel offers multi-language feature, press this button to toggle between languages. To automatically turn off the unit after 0:30, 1:00, 1:30, 2:00 or 2:30. Allows you to instantly switch to three (3) brightness level. *To watch TV/Video in a small screen on an always on top of the PC display. [. . . ] Note: You can also use the CHANNEL setting to switch to composite VIDEO, S-VIDEO or YPbPr. Scan down or up and choose a TV frequency. When FAST TUNING is disabled, pressing Vol or Vol once changes the TV frequency by -/+ 0. 25MHz; pressing and holding down Vol or Vol continuously changes the frequency by -/+ 0. 25MHz and stops when an active channel is found. When FAST TUNING is enabled, pressing Vol or Vol once goes to the next frequency that's in the TV frequency table; pressing and holding down Vol or Vol continuously scans through the frequencies in the TV frequency table and stops when an active Note: After you have found a desired frequency, assign a CHANNEL number, adjust FINE TUNING, and select a VIDEO SYSTEM for that frequency. Then save your settings before locating another TV frequency. If the reception of the selected channel is not clear, choose FINE TUNING then press the Vol or Vol button until the TV picture becomes clear. Use the Vol or Vol button to select the video standard used in your region. You can set this to AUTO to make AVerTV Box9 automatically detect the video system, or you can manually choose between SECAM, PAL or NTSC. You can SYSTEM1 choose between D/K or B/G. use the Vol or Vol button to AUDIO select the audio system. You can SYSTEM 2 choose between MONO, NICAM Select YES if you want to enable fast tuning and scan through available frequencies only in the TV frequency table when you are choosing a frequency for a channel. By default, NO is selected which allows you to scan through frequencies at intervals of 0. Press the Vol button to change this item to OK and save the settings. Note: After selecting a TV frequency and assigning a channel number, save the channel first before choosing a TV frequency for another channel. This menu allows you to enable or disable a channel, reprogram or reassign TV frequencies with channel numbers that are easier to remember. A channel is enabled when there is a "+" sign indicated; a channel is disabled when there is a "-" sign indicated. to enable or disable a channel , press Vol. To reassign a TV frequency to another channel number, first select the original channel number and hold down the Volbutton. While the original channel number is blinking, press CH or CH continuously until you reach the new channel number. Press Vol or Vol to balance the sound of your left and right speakers. [. . . ] All cables used to connect the computer and peripherals must be shielded and grounded. Operation with non-certified computers or non-shielded cables may result in interference to radio or television reception. Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. DISCLAIMER No warranty or representation, either expressed or implied, is made with respect to the contents of this documentation, its quality, performance, merchantability, or fitness for a particular purpose. [. . . ]