User manual AVERMEDIA AVERTV HYBRID+FM VOLAR

[. . . ] AVerTV Hybrid+FM Volar User's Manual English DISCLAIMER All the screen shots in this documentation are only example images. The images may vary depending on the product and software version. Information presented in this documentation has been carefully checked for reliability; however, no responsibility is assumed for inaccuracies. The information contained in this documentation is subject to change without notice. COPYRIGHT © 2006 by AVerMedia TECHNOLOGIES, Inc. [. . . ] To rename a program list, follow the steps described below: 1. Click the Setup button and in the Setup dialog box, click Analog TV or Digital TV icon on the left pane. Click Advance located in the lower right corner of the Program Information section. Then the Advance dialog box will appear. Type the desired name in the Program List Name text box. 3. 4. Press Apply to save the setting and click OK to exit the dialog box. Or press Cancel to abort the saving. 3. 8 Removing Unwanted Channels If you want to exclude undesirable channels from your channel list, do the following: 1. Click the Setup button TV icon on the left pane. and in the Setup dialog box, click Analog TV or Digital Click Advance located in the lower right corner of the Program Information section. Then the Advance dialog box will appear. In the Program Information section, select the unwanted channel and then click Delete. This channel will be removed and that means you won't be able to access these programs anymore. 3. 24 OR, If you just want to skip a certain channel, do the following: 1. First, select the unwanted channel in the Program Information section. Clear the Enable check box so that you will not access that channel when you press Channel Up/Down buttons. However, you can still see the channel in your program list. If you want to watch that channel again at some point, just select the Enable check box. 3. 9 Using the OverScan Function On some broadcast channels, you might see distorted lines or black spaces on the top, sides, or bottom of the screen. These video artifacts device from the source signal, and can be masked using the OverScan feature. To hide the edges of the picture: Right-click on the TV Monitor and choose OverScan to have it enable it. OR, Click the Setup button and in the Setup dialog box, click Analog TV or Digital TV icon on the left pane. Enable Overscan and specify an appropriate number (0~20) to get better quality. You can see the difference from the pictures below: Before using OverScan function After using OverScan function 25 3. 10 16-Channel Preview The 16-Channel Preview function can display 16 TV channels on-screen at the same time. You can see clearly which TV programs are currently showing on these channels. Click to open the Numeric Panel. Click the 16-Channel Preview button. The screen will be gradually filled up with 16 TV channels, starting from the currently selected channel. [. . . ] Just double-click this icon, you can immediately watch live TV or listen to the radio. 6. In the Program Setting section, select the video source, group and channel you want. Set the schedule to tune in live TV or to perform recording. You can set the schedule on Once, Daily or Weekly. [. . . ]