User manual AVERMEDIA DVD EZMARKER 7 QUICK INSTALLATION GUIDE

[. . . ] This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] No warranty or representation, either expressed or implied, is made with respect to the contents of this documentation, its quality, performance, merchantability, or fitness for a particular purpose. Information presented in this documentation has been carefully checked for reliability; however, no responsibility is assumed for inaccuracies. The information contained in this documentation is subject to change without notice. In no event will AVerMedia be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use this product or documentation, even if advised of the possibility of such damages. All other products or corporate names mentioned in this documentation are for identification and explanation purposes only, and may be trademarks or registered trademarks of their respective owners. No part of this document may be reproduced or transmitted in any form, or by any means without the prior written permission of AVerMedia Technologies Inc. Reserves the right to modify its models, including their characteristics, specifications, accessories and any other information stated herein without notice. The official printout of any information shall prevail should there be any discrepancy between the information contained herein and the information contained in that printout. 0 port Sound card Graphic card with 256 MB of memory CD / DVD burner 1 GB for VCD/ 5 GB for DVD or higher of available hard disk space Windows XP SP2 / Windows Vista / Windows 7 Use the figure below to connect your AVerMedia DVD EZMaker 7. To record video with sound, you need to specify the audio input source and make sure the sound is NOT muted and have enough volume. To do this, double-click the yellow speaker volume icon on the taskbar or click Start, point to Programs > Accessories > Entertainment and then click Volume Control. Refer to the Volume Control Help Contents and look for "Adjust the recording volume" for more information. [. . . ] After you have completed installing the driver, you can install CyberLink PowerDirector to edit the video or install CyberLink PowerProducer to make movie disc. At present, VIA KT400, KT333 and K266A chipset motherboards are not supported; VIA 8235 and VT6202 chipsets can only operate on Windows® XP & 2000. [. . . ]