User manual AVITAL 3000

[. . . ] Whenever the vehicle is being serviced or valet parked, place the system in Protected Valet Mode to prevent accidental or unauthorized remote starting. See "Protected Valet Mode" on page 7. AviStart 3000 Owner's Manual Table of Contents AviStart 3000 . Remote Engine Start - Safety and Counter-Theft . User-Programmable Temperature-Controlled Starting Pit Stop Mode . [. . . ] · The engine RPM rises above preset level. · The remote control START button is pressed. · The 20 minute run time expired. Visual Fault Indication When you press the remote control button to start your engine, the AviStart's built-in fault detection system will automatically scan all of the safety zones. If a fault is detected, the system will prevent your engine from remote starting and provides a visual indication to show where the fault has occurred. The parking lights will flash 1 time if a hood switch fault is detected, 3 times if a brake switch fault is detected and 4 times if the system is in "Protected Valet Mode" (see page 7 for a description of this feature). If this occurs, you may need to bring your vehicle to your authorized Avital dealer for service. Remote-Controlled Door Lock/Unlock* To Lock the Doors Press the remote control LOCK/UNLOCK button for 1-2 seconds. The doors will lock and the parking lights will flash twice. * If your system was installed with this door lock/unlock feature, all other door lock/unlock related features will apply. 4 AviStart 3000 Owner's Manual To Unlock the Doors Press the remote control LOCK/UNLOCK button for 1-2 seconds. The doors will unlock and the parking lights will flash once. Remote Engine Start - Operation Your AviStart system will start your vehicle engine with a touch of a button on your remote control. Before remote starting, ensure the vehicle is in "Park" and the key is not in the ignition. To cool or warm the interior of your vehicle, preset the climate control to your preference (heater, defrost or air conditioning). Set the fan to a medium speed (not maximum). To Remote Start the Engine 1. Press the remote control START button for 1-2 seconds, 10-15 minutes before you enter your vehicle (this will allow the climate control time to heat or cool the interior. ) The parking lights will flash 2 times, the engine will start and the parking lights will remain on as a visual indication that the engine is running. If you have a diesel engine, the AviStart will be programmed to start 15 seconds after the parking lights flash 2 times. This will allow time for the glow plugs to heat up. If the engine does not remote start, the AviStart system will attempt to start the engine two additional times. If the vehicle is left unattended, the engine will run for 20 minutes and then shut off automatically. To Operate the Vehicle While Remote Started 1. Press the remote control LOCK/UNLOCK button for 1-2 seconds. The doors will unlock and the parking lights will flash once. Enter the vehicle (do not touch the brake pedal), turn the ignition key to the "ON" position and then press the brake pedal. Pressing the brake pedal will shut off the remote start and parking lights but the engine will remain running. [. . . ] The piezo beeper will beep once for OFF, twice for 5°F (-15°C). The piezo beeper will beep once for -7°F (-20°C), twice for -22°F (-30°C). -- 7 Programming Table for Remote Controls Feature Remote Door Lock/Unlock Remote Engine Start Remote Engine Stop Temperature-Controlled Start Active/Inactive One Step Remote Control Code Learning Instant Remote Control Code Deletion Factory Setting LOCK/UNLOCK Button START Button STOP Button START + STOP button LOCK/UNLOCK Button -- No. of beeps 9 10 11 12 13 14 Secondary Action Press the LOCK Button, the piezo beeper will beep 1 time. Press the START Button, the piezo beeper will beep 2 times. [. . . ]