User manual AXIS 250S MPEG-2

[. . . ] AXIS 250S MPEG-2 Video Server User's Manual 2 AXIS 250S User's Manual About This Manual This manual is intended for administrators and operators of the AXIS 250S MPEG-2 Video Server, and is applicable for firmware release 3. 02. Later versions of the document will be posted to the Axis Web site, as required. Previous experience of networking will be of use to the reader when installing and using this product. Some knowledge of UNIX or Linux-based systems would also be beneficial, for developing custom programming scripts and applications. technician for help. [. . . ] Simply select the item to use and then choose whether to use the default setting or to specify your own. For many of the items, selecting Own will also require you to specify the location for the resource, for example, the location of the background picture you wish to use. When you are satisfied with the new layout, click Save. Note: Unchecking the Show Setup link will mean that the administration tools will then only be accessible by entering the full admin address into the browser's URL field; for example: http://172. 21. 1. 200/admin/. Please make a note of the address for your server, for future use. 28 Administration & System Options AXIS 250S User's Manual Administration & System Options This section lists and describes the administration tools used for the general configuration of the AXIS 250S - the System Options. The topics covered are, for example, network settings, date and time settings, users, etc. For information on general usage and how to set up event types, etc. , please see Operating the AXIS 250S, on page 15. The product cannot be configured before it is installed. If you have not yet completed the installation, please refer to Installing the AXIS 250S, on page 11. Only the product's administrator(s) is allowed access to these settings. Important Notes! · The default password (pass) for the pre-configured user (root) should be changed as soon as possible. Until this has been done, the security features in the product will not be enabled. Furthermore, all Axis products are shipped with the same password by default. For further information, refer to Users, on page 29. · When accessing the AXIS 250S for the first time, you will not be required to log in. · Javascript must be enabled in your browser for the AXIS 250S Web-based interface to work. Accessing The System Options The System Options can be used for configuring the AXIS 250S at any time. Follow the instructions below to access the System Options from your browser: 1. Start your browser and enter the IP address of the AXIS 250S in the address field, e. g. http://172. 21. 1. 200 2. The first time the product is accessed there will be no need to log in. After the Live View page opens, click on the Setup link and then select the item you wish to configure from the System Options. The system is configured and modified directly from these pages. This can be done from any computer on the network that can access the unit. [. . . ] Max:-39. 0 dBu (25 mVpp) Stereo microphone input - Low sens. Max:-18. 1 dBu (270 mVpp) Line input - Max:+2. 7 dBu (3. 0 Vpp) Supported Network protocols - TCP/IP, HTTP, FTP, SMTP, NTP, ARP, DHCP, BOOTP. Terminal block connector A - 2 digital inputs (max 12V in) and 1 transistor output (max 24V, 0. 1 A). 1 pin for ground. Terminal block connector B - 2 digital inputs (max 12V in), 2 pins for RS-485 serial communication. Pre/Post Alarm Buffer - Approximately 3 MByte memory allows up to 1 minute (at low bit rate) of pre/post alarm video storage. Serial Connector - One 9-pin D-Sub RS-232, max 115 Kbps. [. . . ]