User manual AXIS 25205

[. . . ] Tighten the screw at the bottom to securely affix the camera to the board. Caution: The heater at the front of the housing unit becomes hot when in operation. If applicable, position the cable connected from the DC IRIS socket to the lens so that it does not touch the heater. Caution: Do not over-tighten the screw as you may damage the camera. 6. Position the camera with the board inside the housing as before. Make sure the board is inserted under the lugs beneath the window in its most forward position. [. . . ] A damaged cable may damage the camera, the housing and/or other system equipment. 5. Position the swivel (11) on the end of the bracket arm (12) with the two cables coming through the open slot. Ensure that the swivel is positioned with F (front) at the front and R (rear) at the back. Now position the widget (10) inside the swivel (11) with the cables coming through the opening. Match the F and R on the widget with the F and R on the swivel, assuring that F remains at the front and R at the back. Line up the positioning bolt (13) with the screw hole in the widget (10) and tighten it using the large allen key (1). Position the white rubber seal (9) on the flat face of the swivel (11) by pushing the power cable Power through the off centre hole on the left and the network cable through the off centre hole on the right. The two off centre holes should be positioned towards the back. Network Two off centre holes positioned at the back 9 9. Position the housing (8) on the swivel (11) with the white rubber seal (9) in-between, the CAT. 5 cable going through the larger hole in the black board and the power cable going through the smaller hole. Attach the housing to the swivel by tightening up the four screws held in the swivel. Use the small allen key (2) to do this. 290B Outdoor housing Connecting the camera Warning: Be sure to work inside the housing in dry conditions. Rain water, moisture and prolonged condensation inside the housing may cause serious damage to the camera and disturb the picture quality when in operation. Warning: High voltage - the apparatus works on 100-240VAC. Always ensure that the power is disconnected before starting any work or opening the housing. 1. Open the housing by releasing the two clips on the side. Strip back the mains power cable by 5mm. The minimum cable conductor area for installation of the housing is 0. 5mm2. Warning: Regulations relating to other parts of the system may require a bigger conductor area. You are responsible that the requirements of these regulations are met. 3. Wire the power cables into the terminal block, the cable with the "+" sign must be wired as shown (+) Caution: Ensure that all wires are correctly and securely wired into the terminal block. Tighten the cable tie so that the power cable is held firmly. (+) Wiring diagram 290B 4. All models - attach an RJ45 connector (not supplied) to the network cable allowing sufficient cable to reach the back of the camera. Once you have fitted the connector, plug it into the network connector at the back of the camera. [. . . ] Do not use chemicals to clean the housing as this may affect the powder coat finish. The window should only be cleaned with a dry cloth. Burnt fuses in the fused terminal block can be replaced to reinstate the power supply of the camera. Use a 5A, 250 V AC fuse and ensure that the mains is disconnected before beginning. Specifications Weight Power requirements Approx. [. . . ]