User manual AXIS 25221R3

[. . . ] AXIS 262 Network Video Recorder User's Manual 2 About This Document This manual is intended for administrators and users of the AXIS 262 Network Video Recorder. It includes instructions for using and managing the AXIS 262 on your network. Previous experience of networking will be of use when installing and using this product. Later versions of this document will be posted to the Axis Website, as required. [. . . ] Click > Disk Utilization in the device's Web pages to view and edit how much disk space is allotted to each camera and to view how much free disk space is left. Note: Recordings may be erased if you reduce the disk capacity allotted to a camera. Overwriting data When the recorded data reaches its storage limit, you can configure whether older recorded data is overwritten or not. Click > Advanced Overwrite, select the number of the camera to configure, and then select the ON or OFF radio button for each recording mode. Note: If set to OFF the hard disk can become full and it will not be possible to record any more data for that camera. Replacing the hard disk If the hard disk in the AXIS 262 fails, it can be replaced. A hard disk up to 400 GB can be used, but the recommended size is 160 GB. Note that for the product warranty to be valid: a) the disk must be replaced with the 160 GB replacement disk supplied by Axis (part number 5002-011 ACC HARDDISK 160GB AXIS 262) b) the disk must only be replaced by personnel authorized to do so by Axis. Axis does not guarantee functionality with any other hard disk than the one originally included, or its authorized replacement. Note: If a disk larger than 160 GB is used, the maximum number of users will be decreased Caution! The electronics of the AXIS 262 can be sensitive to Electrostatic Discharges (ESD). Be sure to take proper precautions when replacing the hard disk, e. g. Make sure the power cable is disconnected before removing the cover to avoid electrical hazards. AXIS 262 - Hard Disk To replace the hard disk: 1. Unscrew the cover screws (two on each side and three on the back, see AXIS 262 rear panel, on page 7) of the AXIS 262. Disconnect the hard disk's IDE and power cables. Unscrew the two screws that fix the hard disk bracket to the AXIS 262. Remove the bracket, and loosen the screws that connect the hard disk to the bracket. Insert a new hard drive into the bracket and screw the bracket to the base of the AXIS 262 again. Attach the power and IDE cables, replace the cover and reconnect the power cable. Note: Ensure that the jumper settings on the new hard disk are set to master. Flash memory 29 a. Disconnect power and IDE cables Hard disk drive b. Loosen the screws that fix the bracket to the base c. The hard disk bracket can then be removed 30 AXIS 262 - System Options System Options There are different system options that can be configured in the Setup pages, e. g. date & time, network settings and upgrading the firmware in the AXIS 262. [. . . ] PAL is the standard format used for televisions in most of the world (other than the US, Canada, and Japan). Analog signal converted directly to a digital. Ping - A small utility used for sending data packets to network resources to check that they are working and that the network is intact. Pre/post alarm image - The images from immediately before and after an alarm. [. . . ]