User manual AXIS 292

[. . . ] AXIS 292 Network Video Decoder User's Manual Installation instructions are also available in German, French, Italian and Spanish in this manual. 2 About This Document This manual is intended for administrators and users of the AXIS 292 Network Video Decoder, and is applicable for software release 4. 20. It includes instructions for installing, using and managing the AXIS 292 on your network. Previous experience of networking will be of use when installing and using this product. Later versions of this document will be posted to the Axis Website, as required. [. . . ] Run the Ping command (in a Command/DOS window, type ping and the IP address of the unit). If you receive: Reply from <IP address>: bytes = 32; time = 10 ms. . . . . - this means the IP address is already in use by another device on your network. You must obtain a new IP address and reinstall the unit. If you receive: Request timed out - this means that the IP address is available for use with your video server. In this case, check all cabling and reinstall the unit. The AXIS 292 cannot be accessed from a browser Proxy If using a proxy server, try disabling the proxy setting in your browser The IP address has been changed Press the Video Select button on the front of the AXIS 292 to see the IP address on the TV monby DHCP itor screen. Other networking problems Test the network cable by connecting it to another network device, then Ping that device from your workstation. Check that the host name and DNS server settings are correct Verify that you are using an AXIS PS-K power adapter. Contact your Axis dealer. The AXIS 292 can not be accessed via a host name. Wrong host name Faulty power supply Hardware failure The Power indicator is not constantly lit The Status and network indicators flash at short intervals AXIS 292 - Troubleshooting The Status indicator LED is flashing red and the AXIS 292 is inaccessible A firmware upgrade has been See the Emergency Recovery Procedure above. interrupted or the firmware has otherwise been damaged. No image or slow updating of images on video out The video source is too heavily loaded Network bandwidth not sufficient Poor image quality on monitor Wrong PAL/NTSC settings Check PAL/NTSC settings. Video source has been configAdjust the video source configuration. ured with low resolution or high compression. Wrong cabling Cannot connect to the video source Video source is no longer available. Wrong user/password to the video encoder. Check if the video source is accessible from a PC. Check if the source has been turned off, if it has received a new IP address or if the password has changed. Change the AXIS 292 settings accordingly. Check the IP address to the encoder in the Video Source list in the AXIS 292. Ensure the address does not use an http:// prefix. [. . . ] The 32-bit IP address is made up of four groups (or quads) of decimal digits separated by periods. An example of an IP address is: 192. 168. 0. 1 JPEG - A standard image format, used widely for photographs. LAN - A local area network (LAN) is a group of computers and associated devices that typically share common resources within a limited geographical area. Linux - A popular operating system, which is "open source" and practically free of charge. [. . . ]