User manual AXIS 70U

[. . . ] Axis Network Document Servers User's Manual AXIS 70 AXIS 70U AXIS 7000 Network Document Servers User's Manual 2 User's Manual Axis Network Document Servers Notices Take some time to read through the safety notices before installing the Network Document Servers. Please observe all safety markings and instructions when using this product. Do not proceed beyond any of the above notices, until you have fully understood the implications. Caution!- must be observed to avoid loss of data or damage to your equipment. - must be observed to avoid operational impairment. Copyright Information - The unauthorized copying of materials that are covered by copyright and other international USA - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Enter your password and press Menu (on the control panel) or press Tab (on the keyboard): Password: 3. If NT Authentication is enabled, the following prompt will appear: Domain: Default 92 Using the Document Server 4. The following message will appear: Login in progress User's Manual 5. If the following message appears the authentication process has failed. Press Cancel (on the control panel) or press Esc (on the keyboard) to try again. Login failed! 6. If the authentication process is successful the following message is displayed informing you that you can log out by pressing Cancel for two seconds (on the control panel) or Esc (on the keyboard). To logout press Cancel 2 sec. 7. To continue press any key or wait until the following message appears: Send to: xxxxxx Note: If no destinations are set the display will show the Add Address: prompt. Sending to Destinations Note: Before sending to an e-mail address or a file, the Administrator must have set up the destinations as described in "Specifying Destinations" on page 57. Perform these instructions from the Document Server control panel: User's Manual Using the Document Server 1. The Document Server display shows "Send to: xxxxxx" when it is ready for use. For example: Send to: Accounting Dept 93 2. Use scrolling keys to find your required destination from the list. Press and hold the key to autorepeat scrolling. If you want to add a temporary E-mail destination, refer to "Adding Temporary Destinations" on page 95. Note: If a keyboard is connected you can easily search the list by pressing the first letter of the required destination. 3. If you want to send the image to more than one destination, press Select to choose each destination: Send to: +1 Accounting Dept Note: When sending to a printer, the image can not be sent to another destination type and is only sent to one printer at a time. 4. Repeat steps 2 and 3, until all desired destinations are selected. Note: Be careful not to transmit images to an unwanted destination. The scanned image is always sent to the destination shown in the display, whether explicitly selected or not. 5. Optionally, press Menu to change the default settings for scanning parameters. You can select temporary settings for profile, paper size and double-sided. Use to select the desired value. Note: Press the Cancel button to reset all temporary settings to the default values. 6. Insert a single page into the flatbed or a stack of paper into the sheet feeder of the attached scanner device. 94 Using the Document Server User's Manual One single page or a stack of paper in the sheet feeder: a. Press Add to scan and send the image to the destination in Several separate pages or stacks of paper: to scan each page or stack. Insert the next page or stack and press Add again. Repeat the procedure until all the pages have been scanned. [. . . ] A protocol for accessing on-line directory services Line Printer Daemon. A protocol for network printing Light Emitting Diode An underlying definition or description DSN duplex FTP HTML HTTP IP IPC JFIF JPEG LCD LDAP LPD LED Meta User's Manual MDN MIB Glossary Message Disposition Notification. A method used to confirm the delivery of e-mails Management Information Base. A database of network configuration information used by SNMP and CMIP to monitor or change network settings Connector used on a PC to connect a keyboard. [. . . ]