User manual AXIS SHDUG

[. . . ] AXIS StorPoint NAS 100 User's Guide Read Me First 1 Read Me First This guide applies to the AXIS StorPoint NAS 100 network hard disk server with firmware release 1. 00 and subsequent releases until otherwise notified. It is intended for anyone involved in installing and using the StorPoint NAS. It includes the most basic instructions on how to get your StorPoint NAS up and running. For a more detailed description of the StorPoint NAS 100 and its functionality, refer to the "AXIS StorPoint NAS 100 User's Manual" which is available in PDF format at the Axis Web Site and on the AXIS Online CD. [. . . ] The Network Settings Wizard dialog appears. 4. Click Start to proceed with the installation. Open the NetWare (NCP) page and verify the settings. To verify that the StorPoint NAS was successfully installed, check the Event Log for errors. Verify that the NDS tree is synchronized. Use a standard text editor such as Notepad to edit the configuration parameters. From Windows Explorer or File Manager, locate the StorPoint NAS configuration file config. ini file which is located in the System/ServerProperties folder. In NetWare, the default name of your StorPoint NAS is AXIS<nnnnnn>_NW where <nnnnnn> are the last six digits of the StorPoint NAS serial number. AXIS StorPoint NAS 100 User's Guide Setup for NetWare (NCP) 19 3. Enter the appropriate settings for the following parameters: Parameter name TimeZone TimeSyncSource NDSEnable NDSTreeName NDSServerContext NDSAdminName Value = = NDS = yes = = = Description Must be set to the correct time zone that the StorPoint NAS is operating in. Set to NDS to enable the StorPoint NAS to get its time from the NetWare network. Specify the name of the tree where you want to install the StorPoint NAS, e. g. MEDCORP Specify the distinguished name of the context in the NDS tree where you want to install the StorPoint NAS, e. g. Manufacturing. Medtec Specify the distinguished name of a user or administrator with Supervisor or Create rights to the context where you want to install the StorPoint NAS, e. g. Admin. Medtec Specify the password of the administrator entered in NDSAdminName shown above. Once written, this password will appear as ******. NDSAdminPassword = NDSInstall NDSRightsStorage = install Change this to install when you are ready to install the StorPoint NAS. Forced will overwrite the existing server object without warning. = NDS Set to NDS to store the access rights in the NDS tree. Set to File to store the access rights in a file on the Novell server. This is necessary if you do not allow schema extensions in your NDS tree, or if you do not have Supervisor access rights. If storing the access rights in a file on the Novell file server, specify the whole path to the file, e. g. CORPSERVER/SYS:NASSERVER/NASSRV. DAT The specified directory must exist and the StorPoint NAS must have Read, Write, Create, Erase, Modify and File Scan rights. The StorPoint NAS will create the file once you start adding trustees. [. . . ] The StorPoint NAS will now match the disks and start to make identical images in pairs. The number of available volumes will be reduced with the number of pairs that were matched. The automatic selection is based on disk size to match disks closest in size, and the result is displayed on the Web page. Immediately after matching the disks, the StorPoint NAS will start to make the pairs identical. [. . . ]