User manual AYP AYP-PART-NUMBER-164258E PARTS-LIST

[. . . ] R ENGLISH ESPAÑOL Instruction Manual Manual de Instrucciones Manuel d'Instructions PPB2000T WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. [. . . ] Don't handle plug or unit with wet hands. If powerhead is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to your authorized service center for repair. S Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit or outlet to be used for the powerhead. Receptacles are available having built-in GFCI protection and may be used for this measure of safety. DOUBLE INSULATION CONSTRUCTION Your powerhead should be double insulated to help protect against electric shock. Double insulation construction consists of two separate "layers" of electrical insulation instead of grounding. Tools and appliances built with a double insulation system are not intended to be grounded. Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal electrical insulation failure. WARNING: All repairs to an electric powerhead, including housing, switch, motor, etc. , must be diagnosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be identical to the parts they replace. A double insulated appliance is marked with the words "double insulation" or "double insulated". The symbol (square within a square) may also be marked on the appliance. Failure to have the unit repaired by your authorized service dealer can cause the double insulation construction to become ineffective and result in serious injury. UNIT/MAINTENANCE SAFETY WARNING: Disconnect powerhead spark plug (or disconnect powerhead from power source) before performing maintenance. Make sure all fasteners are in place and securely fastened. S Maintain unit according to recommended procedures. S Have all maintenance and service not explained in this manual performed by an authorized service center. S Throw away tines that are bent, warped, cracked, broken, or damaged in any other way. Replace parts that are cracked, chipped, or damaged before using the unit. Never use wire, wire rope, string, flailing devices, etc. S Be sure tines stop turning when engine idles (see CARBURETOR ADJUSTMENTS section of powerhead manual). S Remove the tines before making carburetor adjustments. S Keep others away when making carburetor adjustments. S Never start the unit with the clutch housing removed. [. . . ] Replace the tines and the felt cushions. 6 5. Reinstall clevis pins and hitch pin clips. NOTE: When installed correctly, the hubs on the tines will face each other. The letters "R" stamped on the tines will be on the right side of the cultivator and the letters "L" will be on the left side. STORAGE steps after each use: S Allow attachment and gearbox to cool before storing or transporting. [. . . ]