Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual B-52 ST6012. We hope that this B-52 ST6012 user guide will be useful to you.
Lastmanuals help download the user guide B-52 ST6012.
Detailed instructions for use are in the User's Guide.
[. . . ] IMPORTANT SAFETY INSTRUCTIONS!
1) 2) 3) 4) 5) Read these instructions. DO NOT turn on the ST-6012 without the loudspeaker connected. Be extra cautious when moving the ST-6012 during rain or while transporting it over wet surfaces as water might splash onto the amplifier. Do not block any ventilation openings and operate in accordance with manufacturer's instructions. [. . . ] OVERDRIVE VOLUME: Controls the overall signal level of the overdrive channel. CHANNEL SWITCH: Push switch selects between the clean 60 WATTS RMS and overdrive channels. Activated LED lights indicate which channel is in use. CLEAN CHANNEL VOLUME: Controls the overall signal level 8 OHM / 4 OHM
(4 & 8 OHMS PARRALLEL JACKS)
7
8
9
10
CH. SW.
11
V
21
22
23
GND LIFT
LOUDSPEAKER OUTPUTS 25 24 60 WATTS RMS
16 OHMS (4 & 8 OHMS PARRALLEL JACKS)
26
8 OHM / 4 OHM
All-Tu
4
21. AC INLET & FUSE HOLDER: Connects AC powercord as well as contains primary fuse. 3-SETTING RECTIFIER SWITCH: SOLID-STATE Gives tightest low-end definition and fastest attack. TUBE AB1 Punchy, warm and tighter definition than Tube A. TUBE A "Vintage" attack and feel. GROUND / LIFT SWITCH: Removes ground from the circuit to eliminate 60-cycle hum.
21
22
23
24. 16 OHM LOUDSPEAKER JACK: Connects loudspeakers(s) that require a 16 Ohm load. EXTERNAL LOUDSPEAKER JACKS: Connects the ST-6012 to external loudspeakers such as the ST-412V or ST-412S with a 4 Ohm or 8 Ohm load. SPEAKER SELECT SWITCH: Allows you to select appropriate 4 Ohm or 8 Ohm load loudspeakers. You must ensure that the switch is set to appropriate impedance rating that matches your loudspeaker. Note: Ensure that loudspeaker impedance matches the correct jack connectors.
24
25
26
All-Tub
CLEAN
MASTER
ON
10
ON
VOLUME
0
10
BASS
0
10
MIDDLE
0
10
TREBLE
0
10
REVERB
0
10
MASTER
0
PHONES
12
OLUME
0
13. 17.
be Professional Amplifier
ST-6012
of the clean channel. Adjusting the volume control enables you to 18. INPUT / PHONE JACK: Connects headphones to the ST-6012. produce sparkling clean sounds to crunchy, dirty blues. STANDBY ON/OFF SWITCH: Allows the ST-6012 to remain PHONES ON for limited periods of inactivity without the risk of 10 0 10 10 0 0 10 0 turned settings 10 produce pure clean tones. Turning0this control clockwill wise will gradually produce moderate distortion. damaging / over-heating the amplifier tubes. [. . . ] Products replaced or repaired under this warranty will be returned via ground-shipping-within the United States-freight prepaid. is not responsible for costs associated with expedited shipping, either to E. T. I. or the return of the product to the customer. INCIDENTAL OR CONSEQUENTIAL DAMAGE: In no event will E. T. I. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE B-52 ST6012
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual B-52 ST6012 will begin.
