User manual BABYLISS E764XDE

[. . . ] Full autonomy of the unit will only be obtained after three complete recharge cycles. CHARGING THE CLIppER Before using the clipper for the first time, allow it to charge for 16 hours. MAINS USE Connect the transformer into the mains, wait 1 minute and then switch into the ON position. [. . . ] You will soon know the lengths of each guide and each position. Always move the clipper against the direction of hair growth. Place the guide on the scalp and move the clipper toward the crown of your head. Move your clipper slowly, pointing the teeth of the guide slightly upward. Keep the clipper in contact with your head at all times. For the crown of the head, move from front to back, that is, from your forehead to the crown of your head. For the finishing touches, that is, around the nape and sideburns, use the clipper without a cutting guide. Turn your clipper over and move it from top to bottom. If you want a length greater than 30 mm, or if you are experienced, you can create `comb' or `finger' cuts: - Work without a cutting guide. - Take up a small section of hair with a comb or in your fingers. - Move the comb or your fingers along the section of hair to the desired length. - Cut your hair along the comb or your fingers. - Remove the cut hair using a comb and check the evenness of the cut regularly. This technique allows you to thin out hair to make styling easier. The technique is particularly good for the crown of the head where hair is usually thicker. To thin you hair, take a section of hair (rest your little and ring fingers on your scalp, using the middle and index fingers to set the length), hold 1 to 2 cm below the cutting length. [. . . ] BaByliss oil is specially formulated for clippers, it will not evaporate or slow the blades down. You can get new blades when these are worn or damaged. 2 distanskammar för 22 längder (från 3 till 18mm och från 21 till 36mm, med 1, 5mm per steg) 2. [. . . ]