User manual BABYMOOV BABYPHONE EXPERT CARE

[. . . ] €¢ Battery condition indicated on both the transmitter and receiver, and alarm when batteries need changing or recharging. WARNINGS - The Baby monitor Expert Care should not be seen as a medical device. In addition to using Baby monitor Expert Care, it is strongly recommended that an adult checks on your baby directly, on a regular basis. Premature babies or children considered to be at risk should be monitored by your pediatrician or a health professional. [. . . ] €¢ Place the transmitter about 1 m from the cradle, directing the microphone (4) towards the baby. €¢ Adjust the sensitivity of the microphone by using button (2): press upwards to increase sensitivity and downwards to reduce it (there are 5 levels). €¢ As soon as the transmitter detects a sound, the transmit indicator lights up red. €¢ The night light (1) can be set permanently ON by moving the power ON/OFF switch (6) to position . The night light can also be set to be VOX (voice activated) by momentarily pressing the button 5. Under VOX mode, the night light will be switched on once the microphone detects a sound and automatically goes off a few seconds after the microphone stops picking up any sound. €¢ The condition of the batteries is shown by the battery low indicator “Power” (7). When the battery power is being consumed, the indicator starts flashing. B / Reveiver • Set the power ON/OFF switch (14) to ON position to turn on the unit. The power on indicator (7) will light up steady green. €¢ Place the receiver at a reasonable distance away from the transmitter to avoid feedback. Too close a distance will create a screeching sound. €¢ Once the unit receives a signal from the transmitter, the LED of the visual level meter (9) light up. The louder the baby’s voice, the more number of LED will be lighted up. €¢ The loudspeaker volume can be adjusted by using buttons (10) and (13). Each time you press on one of these buttons, you will hear a “beep” whose volume corresponds to the level you have just selected. If you press button 10 to its lowest level, you will no longer hear a beep which means that your receiver is in mute mode. 10 BABY MONITOR EXPERT CARE • Instruction Manual • This unit is equipped with a vibrating alert. Set the power ON/OFF switch (14) to position , the vibration indicator (11) will light up. Once the received baby’s voice is loud enough, the vibrator starts functioning. To save battery power, it is recommended not to use the vibrating alert frequently. €¢ Once the receiver is beyond the communication range of the transmitter for over 2 minutes, an out-ofrange alarm will be heard and the LED level meter (9) starts flashing. [. . . ] €¢ The transmitter is located close to other electrical apparatus. €¢ Remove the electrical appliances or move the transmitter away from the source of interference or change the channel. • Too short communication range. €¢ A large number of steel structures between the transmitter and the receiver. [. . . ]