User manual BABYMOOV TURBO VAPEUR

[. . . ] €¢ Always wash your hands before preparing a bottle. €¢ Never use the bottle warmer in damp surroundings and do not place directly under the tap. Never immerse the appliance in water or any other liquid. €¢ Never leave the appliance close to any source of heat such as radiators, sunny windows, etc. [. . . ] Fill it with water, following the quantities instructions below. Amount of water to be put in the measuring cup for BW for bottle content in room temperature 6 ml 8 ml 9 ml 9. 5 ml 10 ml 11 ml 12 ml 13 ml 14 ml 15 ml Amount of water to be put in the measuring cup for BW for baby jar in room temperature 10 ml 13 ml 18 ml Amount of water to be put in the measuring cup for BW for bottle content in fridge temperature 11 ml 12 ml 13 ml 14 ml 15 ml 15. 5 ml 17 ml 18 ml Amount of water to be put in the measuring cup for BW for baby jarin fridge temperature 16 ml 18 ml 25 ml Amount of milk in the bottle 60 ml 90 ml 120 ml 150 ml 180 ml 210 ml 240 ml 270 ml 300 ml 330 ml Jar 120 g 200 g 250 g 3. Remove the grille (f) from the bottle warmer. Hold the grille’s handle (g) to CLOSE the grill by turning it anti-clockwise. This will ensure that the steam goes through the steam “steam tongue” (d). Insert the measuring cup/steam tongue (d). Place the bottle inside the stand, without teat and cap. Press the “On” button (e) to start the cycle. The lamp will illuminate to show that the appliance is working. It will go out automatically and an audible alarm will tell you that the cycle is complete. Hold the lid’s handle (a) and turn it clockwise to unlock the lid. For a bottle, add the milk powder, and place the teat and cap on the bottle. Shake it to ensure an even temperature and to mix the milk with the water. Always check the temperature of the food before giving it to your baby. In car - Stop the car / vehicle and keep the engine running. - Place the Bottle Warmer on a flat and stable surface inside your car and vehicle. - Then carry out steps 1 to 17 described above, taking care to reduce the amount of water in the measure by a few millilitres (between 2 and 4ml), and replacing step 13 by the following instructions: 13. Connect the Car Adaptor Plug (h) on to the power cord of the bottle warmer. Plug the Car Adaptor Plug into the cigarette socket. Press the “On” button (e) to start the cycle. [. . . ] Never use any kind of detergent to clean the inside and outside. - The measuring cup and stand can be washed in the dishwasher. De-scaling Do not use any de-scaling products. Depending on how hard the water used is and after a certain period of time, a layer of scale may build up in the tank. [. . . ]