User manual BALAY 3HT545XP

[. . . ] Table of contents Important information . 5 5 6 6 7 7 8 8 9 9 9 11 12 Before using for the first time . If the oven is to switch off automatically . 14 15 16 17 18 18 3 Table of contents Accessories . [. . . ] You may change the temperature or grill setting at any time. 13 If the oven is to switch off automatically Example: cooking time 45 minutes Perform the settings as described in steps 1 and 2. Set the cooking time (duration) for your meal. 3. The oven starts. The duration has elapsed Cancelling the setting Note A signal sounds. Turn the timer back to position D after the signal sounds. Care and cleaning Do not use high pressure cleaners or steam jets. Oven exterior Wipe the oven with water and a little washing up liquid. Do not use corrosive or abrasive products. When this type of product comes into contact with an external part of the oven, clean it immediately. Do clean the oven's external parts with hard metal scouring pads as this may scratch the glass. 14 Slight differences in the colours on the appliance front are caused by the use of different materials, such as glass, plastic and metal. Appliances with stainless steel fronts Always remove any flecks of limescale, grease, cornflour and egg white immediately. Follow the manufacturer's instructions. Try out the product on a small area first, before using on the whole surface. Oven Never use coarse scouring pads or cleaning sponges. Oven cleaner may only be used on enamelled oven surfaces. For ease of cleaning you can switch on the oven light and detach the oven door. Switching on the oven light Detaching the oven door Set the function selector to t. Otherwise stains may appear that cannot be removed. 16 Setting procedure 1. Set the timer to 60. The regeneration procedure takes one hour. Switch off the function selector and set the timer to D. When the oven has cooled Wipe away salt residues from the self cleaning components using a moist cloth. Cleaning the glass panels The glass panel on the oven door can be removed to assist in cleaning. 1. Remove the oven door and lay it on a cloth with the handle underneath. 2. Unscrew the cover at the top of the oven door. To do this, undo the right and left hand screws (Fig. B) Clean the glass panel with glass cleaner and a soft cloth. 4. Make sure that the smooth surface is facing outwards. 5. Refit the oven door. The oven must not be used again until the panel has been correctly installed. 17 Cleaning the rails The rails can be removed for cleaning. 4. Lift the rails at the front in an upwards direction and unhook them, then pull the rails forward and remove Clean the rails using either washing up liquid and a sponge or a brush. To hook rails back into position: Insert the rails at the rear, push them backwards slightly and hook them in at the front. [. . . ] You should also insert the aluminium tray at level 1. The meat juices are collected here and the oven is kept clean. Turn the pieces of meat after two thirds of the cooking time indicated. 22 The grill element automatically switches itself off and back on again. The number of times this happens depends on the grill setting you have selected. [. . . ]