User manual BALAY 3VF911NB

[. . . ] 7 Switching off water softening system . 8 Switching off rinse aid refill indicator . 15 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier. [. . . ] The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting: ­ By pressing the button 3, you can switch the function off : or on :. ­ Close the door. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button P + until the digital display h jumps to : . ­ Press P + or ­ button until the displayed time corresponds with your requirements. ­ Press START button `, timer programming is activated. ­ To delete timer programming, press the P + or ­ button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display h. The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: ­ Open the door. On the digital display h is indicated : . ­ Close the door. 17 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 1R keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. ­ After each washing cycle check the filters for residue. ­ Unscrew filter cylinder as illustrated and take out filter system. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. ­ Regularly clean door seal with a damp cloth. [. . . ] ­ Switch the appliance off ( and turn the tap off. (This prevents residual water from running into the machine control and damaging the programme sequence. ) Removing the appliance Also observe the sequence of worksteps here. ­ Disconnect the appliance from the power supply. ­ Disconnect the waste water and fresh water connections. [. . . ]