User manual BALAY 3VH302NA

[. . . ] instruction manual 9000 481 579 (8907-1) EN Dishwasher y www. balay. es 3 ABC 12 11 10 Reset 3 sec. 9 6 3 Program End Reset 3 sec. Start 1 2 3 4 5 678 9 20 21 22 23 24 25 26 27 28 29 30 31 32 en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 15 15 15 15 16 16 16 16 16 17 17 17 17 17 18 18 19 19 20 20 21 21 22 23 23 23 24 24 24 24 25 25 25 25 26 26 26 Safety instructions . 7 Switching off water softening system . [. . . ] ­ To continue the programme, switch on the ON/OFF switch ( again. ­ Close the door. End of programme The programme has ended when the End display ` is lit. The end of the programme is also indicated by an acoustic signal. The buzzer volume can be set in 4 stages. Accordingly 0, 1, 2 or 3 displays are lit (see water hardness table). This function can be changed as follows: ­ Open the door. ­ Hold down button > P and press START button h until the End display ` and salt refill indicator )* flash. ­ Keep pressing button > P until the salt refill indicator )* and rinse aid refill indicator )" flash. The refill indicators )* and )" flash and the displays # and + are lit (= Setting 2). To change the setting, ­ Press the button < H until the required setting has been selected. ­ Close the door. Terminating the programme (Reset) ­ Open the door. The remaining programme sequence lasts approx. ­ Close the door. 16 en Changing the programme When the START button h has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Open the door. ­ Hold down button > P and press START button h until the End display ` and salt refill indicator )* flash. ­ Keep pressing button > P until the salt refill indicator )* and "Check water supply" )2 flash. To change the setting, ­ Press button < H until the display # is lit (Intensive drying on). ­ Close the door. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. [. . . ] ­ Loosen the fastening screws under the worktop. ­ Pull out the appliance, carefully pulling the hose behind. Protection against frost If the appliance is in a room where there is a risk of frost (e. g. holiday home), empty the appliance completely (see Transportation). ­ Turn off the tap, disconnect supply hose and drain water. 25 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. [. . . ]