User manual BALAY 3VS951BD

[. . . ] Instructions for use en 9000 041 047 (8402) en Index 4 6 6 7 8 9 10 14 auto 3in1 . 15 17 18 20 21 23 25 26 27 Safety instructions . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. [. . . ] The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. Programme progress indicator 9 Your dishes are being washed. The programme has ended. End of programme The end of programme is indicated by a buzzer. This function can be changed as follows: Hold down the Time delay programme button 4 and switch on the Main switch 1 , then release the buttons. The Time delay button 4 flashes and the digital display indicates the value (loud) which was set at the factory. To change the setting: Press the Time delay programme button 4 . Each depression of the button increases the set value by one; when is reached, the display jumps back to (off). The set value is stored in the appliance. Aqua sensor * * on applicable models The Aqua sensor is an optical measuring device which measures the turbidity of the rinsing water. A light barrier can detect dissolved food remnants in the water, e. g. The Aqua sensor is used according to the programme. When the Aqua sensor is active, "clean" rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. In this way the water consumption is reduced by approx. 4 litres for utensils which are "less" dirty. 18 en Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Time delay * * on applicable models You can delay the start of the programme in 1-hour steps up to 19 hours. Press the timer programming button 4 until the digital display 5 jumps to . Keep pressing the timer programming button until the required time is displayed. To delete the timer programming, keep pressing the button until is displayed. You can change your programme selection at any time until the programme starts. Interrupting the programme Open the door. There is a risk of water squirting out from inside the appliance. [. . . ] Water temperature: We recommend that you use cold water. If you do use hot water, the temperature should not exceed 60 °C. Delivery Your dishwasher was checked at the factory to ensure that it was in perfect working order. This may have left some small water stains in the dishwasher. These will disappear after the first rinse cycle. Electrical connection This appliance should only be connected to a 230/240 V AC source via a properly installed earthed socket. [. . . ]